Hey, great Video! I was interested in the more detailed video about the installation?

@PurplePenguinPowa

7 жыл бұрын

I'll make a more detailed one in a few weeks when i'm done exams :)

@TheGweebert

7 жыл бұрын

Moo Mooing Awesome! I appreciate it Lots! Good Luck on exams too. 😊

@PurplePenguinPowa

7 жыл бұрын

Erick Bueno Thanks :)

@PurplePenguinPowa

7 жыл бұрын

Done! check it out! kzread.info/dash/bejne/d51rt6SkorO3pLw.html

@TheGweebert

6 жыл бұрын

Moo Mooing Thanks a bunch! I really appreciate keeping your word. It’s folks like yourself that make KZread great. 👉🏼

If you’ve got a right hand drive auto there’s a massive plastic panel under the steering wheel in the drivers footwell (where the clutch pedal would run through the fire wall if you had opted for a manual transmission ) next to where the port in the firewall shown in this video is. Theres a piece of foam cutout on top of the plastic panel (on the interior) Simply pop the panel out (use a flathead screwdriver) and you’ve got a 10cm by 10cm (estimated) gap for your wiring ( I’d recommend you drill a whole in this for you wiring so you don’t have a giant hole in your firewall and either use some sort of gasket or sealant to prevent road/engine noise in the cabin ). You can also see this panel from the engine bay but it can only be removed from the interior. This is where my fog light wiring and sub power leads run though.

Good job dude. Nice to see how things apply exactly to my type of Mazda. :)

This is much easier than going through the steering column thanks!

@PurplePenguinPowa

4 жыл бұрын

Glad it helped! :)

Hey. Where did you ground it? And how did you do the aux splitter?

I have a 2011 Mazda 3 not Bose system and I tried to find the remote wire but I did not find it and when I put everything back together the display did not work anymore along with the stereo I have no idea what happened. I didn't cut anything all I did was disconnected the connectors and I used a power tester to find what wires gave power but all I found was the constant power and nothing else. Any thoughts on what could have happened

@PurplePenguinPowa

7 жыл бұрын

Enrique Moreno I would double check all the connections, and if they are ok I would check for a loose wire maybe in the wiring harness. For the remote wire, I wired it to the front 12v cigarette lighter outlet because it turns on and off when the car does.

Dawg you couldn't put the LIGHT on for us. Maybe next time I guess. I hope it's the same for the 06 Mazda 3? Thanks bro I'm only teasing lol 😆

Better Version Coming soon!

What if you have a 2011 gt with a bose system

thx my negga

all of the audio wires are readily available so you can still use your head unit and no half ass 3.5mm connector with loss of balance and fade... under passenger seat with Bose system

@PurplePenguinPowa

5 жыл бұрын

Thanks!

by the heater core?... might want to check on it

@PurplePenguinPowa

7 жыл бұрын

J R wait wut

@Motorrad127

7 жыл бұрын

it may be fine but if the power wire rests on the heater core tubes it could possibly get too hot.

@PurplePenguinPowa

7 жыл бұрын

J R oh I see, thanks for the tip. I did order a specific wiring kit so the wire has lots of protection :)

how many feet is the rca you used?

@PurplePenguinPowa

2 жыл бұрын

Probably around 25ft

Why not just drill through the firewall on the left and seal it with silicone?

@PurplePenguinPowa

5 жыл бұрын

Good idea

Didn't watch the video to the end and I was under the impression that the stock hu had rca outs 😂💀 guess I have to buy an aftermarket first

@PurplePenguinPowa

7 жыл бұрын

Yes if you want to wire it to the head unit you will have to buy an aftermarket head unit or purchase a LOC (line out converter) and wire that into the stock head unit.

@ridnlow976

5 жыл бұрын

not true @@PurplePenguinPowa .... i know this is old but you can high level into the amp and keep factory radio

Where did you get your evil m?

@PurplePenguinPowa

Жыл бұрын

Probably aliexpress or amazon

I have a 2010 Mazdaspeed 3 hatchback. I am having a hard time finding where to run the power wire through the firewall

@PurplePenguinPowa

21 күн бұрын

Did you try the same spot as in the video?

@aaronpouncil1615

5 күн бұрын

Having the same problem right now and I’m running 0 gage

A flash light would've helped...

@PurplePenguinPowa

6 жыл бұрын

Good idea!