thank you

Thank you sir

if a mechanical component have a tough gasket and it refuses to be removed what type of hammer is suppose to be used? (it should just bugger off, there's no dowel pin or a guide that holds it in place)

@markszlachetka4897

4 ай бұрын

Glue and patience. Let it dry in place. If there are screw holes like in a valve cover gasket, then you can use bic pen caps and insert them after gluing to keep aligned till cured. The caps are tapered which makes the perfect alignment hold. So when it comes time to put the screw it on the gasket won’t move at all. 😊

@markszlachetka4897

4 ай бұрын

You didn't say what kind of gasket, or are you joking that you want to hit it ? 😂 If serious though, most people have a valve cover gasket start leaking and get on hot exhaust and make smoke, or a lot of smoke. A gasket scraper tool would work on some gaskets, especially cork. Be Careful ! You do not want to damage the surface of metal the gasket will be sitting on, so the lowest angle possible for scrapping. A wire wheel to get the rest so you don't remove any metal at all. A dead blow hammer and gently start tapping the gasket will make it easier. Be patient. You need it clean, as glues are used of different types, and some don't think future, and put permanent glue types, and in that case time and parience is key, and doesn't have to be done all at once. Breaks are necessary as holding yourself up can be tiring, and people tend to rush when tired. 😊

Stephen King brought me here

@StoneDeaf4evr

10 ай бұрын

Lol, same ,poor Dorsey macklin

@batuhanguner8103

7 ай бұрын

which book?

@KUROHiTO88

7 ай бұрын

@batuhanguner8103 Early on in IT (1985) a character gets murdered with a dead blow or recoilless hammer.

@batuhanguner8103

7 ай бұрын

@@KUROHiTO88 Thanks!

@SimpleVisionVideos

4 ай бұрын

I was looking for this comment