How to Replace Rear Axle Shaft & Bearing Kit 2002-2008 Dodge Ram 1500
Buy Now!
New Axle Shaft & Bearing Kit from 1AAuto.com 1aau.to/ia/1AAXS00075
This video shows you how to install a rear axle shaft & bearing kit on your 2002-2008 Dodge Ram 1500. Whether it's due to wear, breakage, or corrosion, a solid axle needs to be replaced sometimes.
This process should be similar on the following vehicles:
2002 Dodge Ram 1500
2003 Dodge Ram 1500
2004 Dodge Ram 1500
2005 Dodge Ram 1500
2006 Dodge Ram 1500
2007 Dodge Ram 1500
2008 Dodge Ram 1500
Tools you will need:
• Pry Bar 1aau.to/oQb/1AXAA00020
• 22mm Wrench
• Bearing Puller
• Bearing Race and Seal Driver 1aau.to/oA/1AXAA00038
• Seal Puller 1aau.to/oe/1AXAA00040
• Slide Hammer
• 1/2 Inch Socket 1aau.to/obtW/1AXAA00016
• 3/4 Inch Socket
• 7/8 Inch Socket 1aau.to/oaX/1AXAA00042
• Torque Wrench 1aau.to/oaxH/1AXAA00044
• 5/16 Inch Wrench
• Gear Oil
• Gloves 1aau.to/oSc/1AXSS00048
• Liquid Thread Locker
• RTV
• Safety Glasses 1aau.to/oKw/1AXAA00343
• Drain Pan 1aau.to/oxj/1AXAA00320
• Floor Jack 1aau.to/oXX/1AXAA00068
• Hammer 1aau.to/oRn/1AXAA00091
• Magnet - Extendable
• Razor Blade / Gasket Scraper 1aau.to/oit/1AXAA00280
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Пікірлер: 27
√ Watch the Video
Nice. I'm reviewing this before I do the same to mine. I'm a bit surprised you don't put any grease or gear oil on the bearing when you install it. Not sure how the oil gets from the dif to the bearing. Is it just the spinning of the axle? Excellent, thank you!
Really helpful
Nice video for replacing rear wheel bearing but ounce you replace the one side do you just pull the otherside off also to change the bearing the same way.
I LOVE TRQ thag they prove it viedios channel! But they post a lot per day i don't feel to finish the at lest to watch one short vedio
Golden information
Good video
Hi, thanks for your video. Can I do the same for a RAM 1500 year 2001 2ND GENERATION? it has drum brakes
Nice thanks
what’s the part that the caliper bolts go through and holds the caliper. it also gets the backplate bolted onto it with the small bolts. it has the 4 bolts
I always put a thin film of clear silicone on the outside of the seal to prevent any leaks. Never had any seals leak by doing that. Cheap insurance.
How do you know u need bearings and a axle I have a popping when I take off and reverse but stops after a few seconds but my drivers side tire has tire wear on the inside
Could you put the tool kit number? The exact bearing puller you used. I did my seal and 1mnth later leaking again. Gonna do both seal and bearing this time
Is this the same for both sides? I am assuming it is?
I assume it is no different for the right rear passenger side as well, correct?
i have a moog bearing, it doesnt need to be packed?
Do these parts fit on a 2007 ram?
I have a 2004 Durango does it gave wheel bearing on both sides of the rear wheels
I hate the way gear oil smells
Qual o oleo do diferencial ?