How to Rebuild Missing Fingertips on a Plaster Handcast
Тәжірибелік нұсқаулар және стиль
The expert sculptors at @Edinburghcasting demonstrate in detail how to rebuild a missing fingertip caused by air bubbles in the alginate mould. The cast shown was made with @Edinburghcasting Handhold Casting Kit.
Shop our full range of world-famous home handcasting kits here: edinburghcasting.com/
Пікірлер: 4
Hello! I just started getting into this but sometimes I'm missing the fingertips! Why? What can I do to prevent this? Please any advise
@anacastro7286
27 күн бұрын
It’s typically because of air pockets in the finger holes. Try pouring in a little bit of your mold mixture and then tapping the container against a hard surface (table,floor) to release any air bubbles. Once you don’t see anymore big air bubbles, continue filling up your mold & once again tap it against a hard surface. Hope that helps!
@tiaalicia1388
27 күн бұрын
@anacastro7286 omg thank you! I even purchased a vibrator to help me out with air bubbles. Should I tip the cup upside down a few times? Just to be sure? Ong that makes so much sense. I knew omit had to be the way if was pouring it up. Gravity wouldn't make the stone go up into the curved fingers if I don't tip the cup over.
@tiaalicia1388
27 күн бұрын
Sorry I misread your message. I don't know why I was think this way as I was writing and totally not talking about what u wrote. I just invisible this idea. 💡 I think I understand the missing piece to the puzzle