Great instruction!

you have electrical tape holding the heat trace to the pex tubing? you might want to look in to that if this is permanent. Something about the adhesive leaching into the pex.

Could you use this to keep palm trees warm? I feel like there has to be a type of heating cable out there that you can wrap around…

For 90%+ efficient gas furnaces in attic applications where the vents are ran in pvc and takes the heat out and turns it into water which ties into A/C condensate lines which are pvc you can run heat cable on it as far as I know

I have a 3-6" gap between 3 pipes, can I jump from one pipe to the next and leave a gap using the heat cable so I have one continuous run for 3 pipes?

Why is everything in a question format ending with an up ⬆️ inflection to the voice?

Cool beans Thx💯

Nice video. We have a easy heat orange cable. Working well for years. Froze up this year. I went down to test. Cant tell if the cable is on or not. I get a voltage reading on the cord it’s plugged into but no reading on the actual braided cable. Yet it is about ten degrees warmer Wondering if there is a fuse in the east heat box that’s plugged into power. It has a few screws.

As you said, the instructions say to put this in-line down the length of the pipe and you can run up to 3 feet of it back down the other side of the pipe to use up any excess length. What do you do if there is more than 3 feet of excess length?

@JamesGlassJamesGlass

Жыл бұрын

You can get different lengths and even custom lengths.

@theshop5331

2 ай бұрын

@@JamesGlassJamesGlass where do you get custom lengths, do you have a link

So you can basically heat both pipes up as long as they're insulated together?

@Off-Grid

Жыл бұрын

We have and it works fine.

Is the insulation a must after the heat tape is applied?

@Off-Grid

Жыл бұрын

Yes, you'll want to insulate it.

@JamesGlassJamesGlass

Жыл бұрын

Yes

They probably don't want it on drain pipes because they can be empty and there is no mass to absorb the heat and it could over heat.

The instructions on my cable say to NOT use it on two cables taped together as it can cause a fire.... I wanted to do what you are doing until I read that.

usual culprit is cables are always the wrong length, impossible to cover correctly

PVC will melt and burn it turn brown or blk.

😮some one told me not to use on drain lines because they are not full of water?