Great ideas.

@stairbuilding

3 жыл бұрын

Glad you like them!

Do you have any videos showing a good supporting connection between the top landing and the long railing posts posts?

@stairbuilding

2 жыл бұрын

I would go to our website and check out the deck and outdoor stair sections.

I notice that the carriage bolts are in a line - do you not advise offsetting the bolts to assist in avoiding splitting? Thanks!

@stairbuilding

4 жыл бұрын

It really depends upon the width of the post and the with lumber you are connecting to. I think in a situation where you have a 4 x 4 post, it might be better to put the bolts in the center or just use one bolt. For example if you moved it over a half-inch to the right, then you might only have about three quarters of an inch between the outside of the post and the inside of the hole you drilled and this might not work good. Let me know this doesn't make sense.

Love your bracket idea

@stairbuilding

3 жыл бұрын

Thanks

How are the (other) support posts fixed to the stringer and the landing? Is bolting though enough or would they have to be notched? Thanks.

@stairbuilding

4 жыл бұрын

Most of the time the posts are attached with some type of building hardware, lag bolts or regular bolts with washers, but there are other ways and notching them might be one of them.

Generally, what is the height of the stair rail? I just dismantled my stairs/landing leading into the house from the garage, but forgot to measure that height.

@stairbuilding

4 жыл бұрын

Minimum guard railing height is usually going to be 42 inches and the gribable handrailing that you would hold onto while using the stairway is usually between 34 and 38 inches.

@rrenee501

4 жыл бұрын

@@stairbuilding Thanks!

Move the post back so you can connect to the lower part of the stringer that will give you more strength don’t connect to the top of the stringer at the tooth go back to the route

@stairbuilding

3 жыл бұрын

What is the route?

@onetwothree4148

2 жыл бұрын

I think they are saying that your example should have spread the bolts out further on the stringer when you moved the post back and had the opportunity to use a larger bolt spacing. The closer your fasteners are to each other the less useful they are against leverage.

put the dam post on the inside instead of the outside and block it just saying

@stairbuilding

Жыл бұрын

Yes, just make stairs a little wider to make sure the guardrail does not make stairway width to small for local building codes.