PAC T advances harness inputs( to amp) go to RCAs if your amp can convert high to low giving signal to speakers without re wiring. Outputs from the other side of the amp Phillips screws go to output (from amp) making one big circle. subwoofer will bounce off the rear signal so then jsut connect the subs to Phillips screws on the amp also known as low level this would apply to 5 channel. I plan on doing this next month took a lot of time to learn but thankfully I got on the phone with Crutchfield and they broke it down. If running components you will need crossover if you have coaxial you will not need, built in cross over already in coaxial . When running inputs to the RCA (TO AMP) you can run a Lc7i etc to clean the stock audio roll off with it attach ferrules then RCA to other side still connecting to high inputs. Hope this helps It’s the same price purchasing the speedwire because you will need two in total about 55 60 bucks and the extension for the pac is 60. Crutchfield can walk you through set up if you purchase through them

is that same harness fird edge 2013 uses

Correct me if I’m wrong, but doesn’t that Kicker CX amplifier you’re connecting to already have high level inputs so there was no need to run a Line Output Convertor?

Where can I buy those wiring harnesses

Hey man, nice video. I have a 2016 F250 with the Sony system. Looking for some help to amplify front components speakers and maybe upgrade the sub.

Nice im going to order for mine with the sony stereo but how would i also add a bass amp and 4 channel with only 4 outputs and also the door speakers are going to be 300 watts rms each should i upgrade the wiring for them?

@FearTrooper

9 күн бұрын

Anything above 75w should be upgraded if you are thinking of using factory speaker wire

Will this harness work for non amplified 2020 f150 with the big screen? Thanks.

@hectorheco5194

Ай бұрын

Yes I ordered for my 2020

@ashtonseale5263

Ай бұрын

@@hectorheco5194 thank you for the reply

Where can I find a wiring harness

@jptheinstallguy

7 күн бұрын

It was in the description but here you go *Parts used for this install are:* pac line output convertor lp74 www.jpsaudio.com/product-page/lp7-4 audio integration harness www.jpsaudio.com/product-page/lphfd21-pac-non-amplified-ford-harness pac audio integration harness extension www.jpsaudio.com/product-page/lphext17-pac-t-harness-extension