Ford Focus Rear Brake Pad Replacement MK1 no extra tools needed
Автокөліктер мен көлік құралдары
The steps in this guide are used to replace the brake pads on all Ford in Europe from 1998 to 2004 and by Ford in North America from 1999 to 2007.
Whenever working on your car's brakes and suspension, work on one side at a time. Keep the other side completely assembled so that you can reference it at any time.
Never drive a car if the brakes on one side only are changed, because the car will "pull" to one side.
Music: Ivan B - Sweaters
Пікірлер: 29
Just what I was looking for. I learned everything I needed. Thanks
@RegisGarage
7 жыл бұрын
Improvement Road thank you very much!
@ohzynk3412
4 жыл бұрын
Regis Garage next time say front waste of time if u can’t do front....
@ohzynk3412
4 жыл бұрын
Regis Garage so where’s back now????
simple video, nice song. thank you!
Thank You Regis Films :)))
@RegisGarage
7 жыл бұрын
спасибо Нюша Лэнд :)
Good video :)
good ..thx
good!
Nice SONG!!!
@RegisGarage
7 жыл бұрын
Music: Ivan B - Sweaters
@sujonix8590
7 жыл бұрын
Thanks :))))
Good
@RegisGarage
7 жыл бұрын
I'm glad you like it Rebecca.
For some reason on my breaks there is so much tension on the handbrake cable but not the actual cable the sheathing around it, it makes it so I can’t get the caliper over the pads
Hi. New brakes are thicker than old . How do you get the plunger/cilinder to go back. Just pressing does not work.
Thank you for the video!My car have the following issue:The hand brake does not work on right wheel. The cable seems to be OK, is moving the lever, but the brake piston is not moving. When I step the brake pedal, is working.So, can be adjusted somehow?
@RegisGarage
6 жыл бұрын
It could be that your break cable is not tight enough. You need to remove your Focus centre console near the handbrake lever. Then you'll see a nut attached to a threaded spindle on the driver's side of the handbrake. Get on it with the 10mm deep socket and start tightening. Put your fingers under the handbrake cable that's exposed behind the lever. Then you’ll feel how loose it is. When it starts putting pressure on your finger, you've probably got it tight enough, or close.
how to change the rear brake disc in same car ?
@RegisGarage
6 жыл бұрын
Would you like me to do a video for you?
@kaheelgym8620
6 жыл бұрын
Regis Garage I wish that.😅😅😅
@RegisGarage
6 жыл бұрын
I need to find a Ford focus for that :D
I’ve done my ones now the handbrake don’t work any idea why?
@RegisGarage
6 жыл бұрын
Is there enough tension on the cable?
@h3ntaihunt3r
3 жыл бұрын
Or did u forget to connect it back up 😂😂😂😂😂🤯
Shame you speeded it up, whats the rush? Music 1/10 for distraction. Overwise good vid!
@RegisGarage
6 жыл бұрын
Thanks for the comment. I was trying not to waste your time and provide as much information :)