Ford 600-800 Steering column leak repair
Фильм және анимация
In this video I repair my for 851 tractor. The power steering column was leaking fluid out of the top of the column. This video shows how to correct the problem and stop the leaking. If you have an early Ford tractor with the same power steering system, this will help you to repair it correctly
Пікірлер: 11
I am very grateful for this video. And yes, the goofy one goes in the 6'o'clock position. Also I had trouble knowing if the valve assembly body was upside down. One of the big fluid connections has an extra nut screwed in between the body and the line. It should go on the starboard side. I call it the passenger side. The rear-most lines should be lower than the middle lines. There's 6 hard lines.
Good job. Facing a similar repair now
Thankyou!!!
does this tractor use oil from the hydraulic reservoir for power steering? or the transmission?
@warrenroberts8806
5 ай бұрын
No, it only uses the power steering fluid from the reservoir on top of the power steering pump
Why does the Service manual pic show the special valve ( with the 2 sleeves and 2 steel balls ) hole is at about 9 oclock you highlighted it with the red arrow, but in your video it looks clearly like you installed it at the buttom hole...6 oclock?.... And add to that the Service manual has no clarity, because it just says "Install....in the same location from which they were removed" ....!!!.... I hate with a passion conflicting opinions. Any insight on this would be appreciated. I can guess, but that's just stupid!
@vernboulet1015
3 жыл бұрын
Did you ever get a reply? I just asked a question also. Wondering.
This was a big help, but as Ty asked - clock orientation of the valve(s)? did it work ok using 6 o'clock instead of 9 o'clock? And the vid doesn't show the orientation of the washers & ball bearings above and below the valve body. Any input on those? My printout of the system disassembled isn't very clear. Thanks (mine is a mod. 621 and has a paper gskt between valve body adapter (that also leaked) and steering box, but is otherwise identical)
@hillbillyrepairman5205
3 жыл бұрын
No , that’s the power of editing, I switched it off camera when I figured it out.
@vernboulet1015
3 жыл бұрын
@@hillbillyrepairman5205 So you're saying 6 oclock didn't work? 9 0clock is the right position?
Video was good but volume was to low couldn't hardly here