I feel like I've been to Ford Tractor school and had the in depth course on power steering ! Wonderfully done !

Tip: Before removing the reservoir cover take a marker and draw a small line across the pump onto the cover. This will give you a point of reference when installing the cover to line it back up exactly where it was.

I really appreciate the detail and care that you put into the work and the video. May God bless and keep you in all your work and service, Dan. You really have a nice looking Ford there and well cared for. It makes me want to do better on my 63 Ford 4000.

Nice job sir, of carefully explaining how to assemble the parts so as to avoid damaging the parts and fittings

Awesome video Dan thanks heaps exactly the video I’ve been looking for 👌

Thank you for the video! This helps a lot.

Good video. Thanks. I've changed the other hydraulic filter at bell housing. haven't done that one because I didn't know a filter existed there.lol

Everything but what kind of fluid do you use

Some old ford trucks 800 series used this same pump. I save 3 for my old ford tractors

The wire that connects to the oil pressure sending unit should just snap on unless the connector is damaged.

What is the easiest way to flush the system. .?

Did you use ATF for power steering fluid

is this how they leak back into the block or is the leak to the block caused by a o ring fail on the drive assembly of the pump?

@j.b.1855

Жыл бұрын

You would have to pull the pump from the engine, and replace the seal behind the gear that drives the pump.

Same on ford 2000

How did you get the cable for the oilpressure to stay put? I Dont get it?

Step One: Have your cameraperson turn the phone sideways.

wearing rubber gloves .......... thinking HARD .... ? something is MISSING ... I don't get it !!!!!!!!!!!

Talk talk.