love your vids! keep at it. Are you heating the board from both top and bottom when taking off the port with lead free solder that factory puts on?

@Wayayeo

Жыл бұрын

Correct. Heat from both sides fir about a min or so depending on the temp.

what does the flux do and how do you use it on the connectors?

What temperature do you use

Desoldered my first one of these today using your video as a guide. No pads got ripped either! Successful pull! It seemed like it took forever heating from the bottom like this, i was afraid i was gonna damage one of those diodes on the bottom. What temp is your air set at? Thank you for this video btw. Outstanding work!

@Wayayeo

8 ай бұрын

Thank you @jrcogburn

Can I use just a regular heat gun? I have just a 1000 watt heat gun. Not sure if you're using something more powerful than that.

@Wayayeo

Ай бұрын

Your heat-gun should work fine just make sure to apply heat to that area only and use heat resistant tape around the area if possible. Good luck.

How come your anti-heat tape doesn't work? me my yellow melting tape, where did you buy it? mine may be of poor quality

@Wayayeo

7 ай бұрын

I get at a small local store. Try Amazon, I have ran across bad quality as well. Try different vendors until you get a good one. Good luck.

How much do you charge To fix an HDMI port to a PlayStation 5

@Wayayeo

7 ай бұрын

The prices and info are on our site. We’ll beat any competitors pricing. Wayayeo.org

What temperature are you using?

@Wayayeo

8 ай бұрын

700 f works for me. It really depends in your equipment. Get to know your tools.

low melt solder would have been faster

Whats the trick

@Wayayeo

Жыл бұрын

Patience and experience.

and that cost sir 100$