Guide on how to install NUTT hydraulic brakes on an electric scooter. I performed the installation on a VDM-10* scooter, replacing the old leaking ZOOM brakes.
The guide should also help when doing the installation on other electric scooters as the main steps will be the same.
If you have any questions or something was not very clear, leave a comment and I will try to help if I can.
If you enjoyed the video please subscribe to my channel and hit the like button. Thanks.
Bleeding hydraulic brakes: • Bleeding Zoom Hydrauli...
0:00 Introduction
0:52 Remove cable wrap
2:23 Draining the oil from the old brakes
3:08 Removing the brake line from the brake lever
4:11 Taking out the old brake line
6:34 Measuring the new brake line
7:00 Putting in the new brake line
9:20 Removing old brake lever and grip
9:58 Mounting the new NUTT brake lever and cutting the brake line to size
11:00 Removing the pin from the cut off line
12:53 Installing the pin
14:35 Attaching the brake line to the new NUTT brake lever
15:58 Testing the new brake
16:58 Putting back the grip
17:07 Soldering new connector to the brake wire cable and attaching the sensor cable
18:33 Finished install
*Apollo Ghost, Techlife X8, etc.
Subscribe button by ‪@PatrickStirling‬
stirlingsupply.co/en-eur/prod...
#electricscooter #apolloghost #pev