Between 1:53 - 2:00 you can see the links are installed incorrectly. The offset is to attach to the swaybar; Per the instructions, Install photos, and our Instagram DMs with you. You have the Driver & Passenger side links swapped. Glad those Eibach links worked out for you none the less. 👍

@Srtfiedofficial

2 жыл бұрын

As I clearly stated in the video they were initially installed incorrectly as per your instructions hence why I didnt try to argue the fact that the bushings wore out the first time. However, after the new bushings were installed and the links were installed correctly as you can see between 4:42 - 5:46 and explained between 7:25 - 8:40 they still failed so the bushings for those links are not the best. You guys make great products but unfortunately these end links just don’t hold up with those rubber bushings.

@bwoodyperformance4220

2 жыл бұрын

​@@Srtfiedofficial Having the offsets wrong initially may have elongated your OE strut hole, causing that noise & failure to persist. The polyurethane bushing would not stand a chance in that case, We do greatly appreciate your feedback. Also, just for reference on those Eibach links - these are installed incorrectly. Those tapered metal bushings are to sit against the heim joints per Eibachs instructions. That bushing is installed on the outside of your swaybar, not against the joint ( 10:37 ) in the video. The strut/ swaybar should not be making direct contact with the heim joint. Those bushings are there to allow free movement of the joints. This could cause future failures and more damage to your strut. Hope this helps.

@Srtfiedofficial

2 жыл бұрын

Thank you for the feedback and ill be sure to adjust those links.

@eldiablort1461

2 жыл бұрын

@@Srtfiedofficial Did you ever adjust these? Seen any more issues?

@Srtfiedofficial

2 жыл бұрын

Yea I adjusted them and installed them correctly a few days later after this video and haven’t had any issues with my sway bar end links clunking since then even though the clunking stopped after the initial install of the eibach links.

Bwoody suggest you grease the fitting every oil change.

@Srtfiedofficial

3 ай бұрын

The fittings were very well greased! Their endlink grommets are just poor quality. Ive had a few friends who had the same issues with their end links.

@Popi_Junior

3 ай бұрын

I believe you and appreciate the video; you helped me eliminate them for suspension use for sure. @@Srtfiedofficial

Yesssirrr !! Savage gang in the building!🔥🔥🔥🔥

@Srtfiedofficial

2 жыл бұрын

Yesssir #SavageGang

Just click the red button,love the video brother,stay bless

@Srtfiedofficial

2 жыл бұрын

Preciate the luv and support as always💯🙏🏽

The Eibachs are great for starting out with no pre load on your sway bar. They’re great for when you corner weight your car.

I have the BWoody ones and love them. Stronger and lighter than stock.

@Srtfiedofficial

2 жыл бұрын

They’re definitely stronger but they arent lighter. The shortened ones i have in the back are just slightly heavier but the front ones definitely weight about a pound or so more

Damn bruh. It's always something aint it!! But that's the battles we choose to fight with these muscle cars... but I'm glad that it was a simple fix and hopefully you won't have the problem again.! 🙏💪

@Srtfiedofficial

2 жыл бұрын

Yea this one was simple luckily

@SPEEDISLIFE35

2 жыл бұрын

@@Srtfiedofficial do you think your bags by having the car so low at times are wearing the rubber bushing out ?

@Srtfiedofficial

2 жыл бұрын

Not the sway bar bushings but definitely the ball joints and tie rods

Those B Woody bushing ate getting leaked on and softening them up.

The Eibach are adjustable for length, a far better product. Hope you sprung for the heavy duty Eibachs. Rose joints can fail as well.

@Srtfiedofficial

Жыл бұрын

Yea the eibachs were the correct choice and replacement and never had an issue after

Mine are installed correctly and are failing too. Gonna get the AAD links that just came out.

@Srtfiedofficial

2 жыл бұрын

Yea AAD makes awesome products as well

@taxinator5858

2 жыл бұрын

Thanks for the update, I did not know AAD now make end links. My Bwoody end links are also failing…I’ve got the clunk noise.

@AJM0201

2 жыл бұрын

@@taxinator5858 Yeah the AAD ones are new on the market and are a superior design 👏

So did these eibach solid style mounts ride well compared to bushings ?

@Srtfiedofficial

Жыл бұрын

Ride quality didnt change between these and the bwoody endlinks! Both performed the same

Where did you get your sway bar end links from?

@Srtfiedofficial

Жыл бұрын

The eibach website

Hopefully you can answer this concern. I just installed the sway bar and the end links, but I hear a slight clunking noise when driving between 20 and 40 miles an hour on bumpy roads. Do you hear the same if you still have them installed on your car.

@Srtfiedofficial

Жыл бұрын

I dont have the scat anymore but when i installed them my clunk issue went away. But it sounds to me that you may need to tighten your swaybar endlinks or get new ones as the ones you have are faulty.

@ismaelperaza3554

Жыл бұрын

@@Srtfiedofficial these are brand new eibach swaybar links with the eibach end links. Also eibach shocks and lowering springs. Everything is to spec. I did it yesterday.

@Srtfiedofficial

Жыл бұрын

Well if you’re hearing a clunk then something is obviously not to spec or you have a part that is bad regardless if its new or not.

Was this your front endlinks also What about your rear endlinks, did u also have bwoody and how did the rears hold up ??

@Srtfiedofficial

Жыл бұрын

Yes those were my front end links. I do still have the bwoody end links in the rear and the rear ones are holding up good. The rear ones arent under as much stress as the front ones are.

@MrFryguy87

Жыл бұрын

@@Srtfiedofficial I figured I ordered a set and when comparing endlinks the front ones were solid links and didn’t have any swivel or joints like the stock ones did so I left my stock ones on, now the rear ones where somewhat identical to the oem except a lot more thicker so I went and added those on

Any feedback on the eibach end links ? I’ve replaced the oem links about 3 times now and they still keep going out.

@Srtfiedofficial

Жыл бұрын

The eibach ones are a better upgrade and due to them not having rubber bushings, they dont wear out like the OEM ones do.

@albertomiranda1554

Жыл бұрын

Thank you for responding. I’ll be ordering a set

@dougsmith1622

Жыл бұрын

The Eibachs are a step up in technology, you can adjust the length while they are on the car. You can dial in the pre load on the sway bar to zero on both ends. Those Bwoody links, because they are fixed length, can unbalance the sway bar a little bit depending on how the corners are weighted. This is important if you want to take your car out for track time, auto crossing, or

In watching the video, the eibach front end links were not installed correctly. The mis-alignment spacers should be on the front side of the heim joint, e.g. sandwiched on the raceway. You have one of the spacers on the backside mount. The spacer orientation in the video, the end link is unable fully articulate.

@Srtfiedofficial

9 ай бұрын

Thanks for the info however i didnt have any more issues with the endlinks after i installed the eibach endlinks and never had any drivability or handling issues after install.

@dcpatters0

9 ай бұрын

@@Srtfiedofficial for sure. And I read how you had no issues. It’s bizarre. I wonder if Eibach has their instructions wrong. Initially, they only included 4 misalignment spacers when I purchased the links directly from them.

@Srtfiedofficial

9 ай бұрын

Maybe, or maybe the spacers placement or location is negligible to the operation of those endlinks as each vehicle is different when it comes to swaybar movement under load and etc. so those endlinks may not articulate to the point where the placement becomes a factor.

What endlink do you recommend for a 22 charger R/T?….

@Srtfiedofficial

Жыл бұрын

Eibach or AAD

@gordo3105

Жыл бұрын

@@Srtfiedofficial ma bad for take some of ur time bro, can u help me out getting the part number for the Eibach Endlink. For some reason I can’t find it .I’m new to this. I appreciate it

@Srtfiedofficial

Жыл бұрын

Front: AK41-27-008-01-20 Rear: AK41-27-008-01-02

@gordo3105

Жыл бұрын

@@Srtfiedofficial highly appreciate it bro ✊🏽

Heard alot of bwoody products are garbage and when they fail they don't support their products and try to blame the customer so they don't have to warranty parts..aad suspension and also upr sway bar links are amazing

Those bwoody looked cheap out the box. Nice and pretty but they did look cheap

It don’t cost me nothing it don’t cost you nothing y’all know the rest 🤛🏿🤙🏿

@Srtfiedofficial

2 жыл бұрын

Yesssir 💯🙏🏽

Those are bushing not grommets, those B woody look like SPC parts....hmmm

@Srtfiedofficial

2 жыл бұрын

Bushings, grommets… you got the gist of what I was saying lol

Fatkat just made a new video,u should watch it

@Srtfiedofficial

2 жыл бұрын

Yea I already checked it out😎

@JuanPerez-hv2bq

2 жыл бұрын

Ok,be safe brother stay bless

That too bad bwoody didn’t make it right regardless. I’m interested in those eibach sway links. I picked up a 17 RT and need to replace mine and the sway bar bushings

@Srtfiedofficial

2 жыл бұрын

Yea the eibach ones are designed much better IMO

Wth