DIY Tacoma Bed compartment and Compressor Installation
Автокөліктер мен көлік құралдары
DIY video of an All Pro Tacoma bed box kit and ARB twin compressor install. If you have any questions, feel free to leave a comment down bellow.
If you want to follow the build, check out my instagram:
@luau.taco
Пікірлер: 7
Clean
Is the female chuck connector blocked?
@LuauTaco
Жыл бұрын
It’s on the top. I’m not gonna use that chuck to connect my hose. I’m actually gonna run a shorter hose to that female check and mount a small pancake tank where the spare tire goes and then have a chuck from that
What up bro I have a question where are you connect the power and ground directly to you, battery or to Fuse box power tray
@LuauTaco
10 ай бұрын
How’s it going man, I’m actually running the harness to my switch pro. I cut up the factory harness and extended it to reach the engine bay. I have the compressor on one switch and the solenoid for the locker is on another switch. Hope that helps
@pedrovilla1000
10 ай бұрын
@@LuauTaco can you show. A video of how you have it connected what wire goes to what?
@LuauTaco
10 ай бұрын
@@pedrovilla1000 it’s kind of hard now because I ran all the wires up and tucked them on the frame. Basically, I used the wiring diagram that the ARB came with and just looked for the wires I needed and extended those.