I'll show you how to make extra keys for your 2016 2017 2018 2019 Chevrolet Volt. Easy job to do at your own home. Avoid dealerships and save money! This also works for the Chevy Cruze and Bolt too! You will need EVERY key fob you want to use for this as it erases all other keys.
1. 0:00 Buy extra keys online. 2017-2019 Cruze and Volt will use "HYQ4EA" 433MHZ keys. The "HYQ4AA" is 315MHZ for older cars. Make sure the buttons match your own and check your frequency/model by opening your key fob and it will be printed on the inside by the battery.
You can buy the correct keys here:
- amzn.to/3PGAWwN
2. 0:30 optional have the backup door key cut on the extra keys. Not needed if you have one good working backup door key, but it's a good idea anyways. Check out my video here where I show you how to set up a new Defu 368A key cutting machine that I use. • Laser cutting our own ...
3. 2:05 Use the backup door key to remove the lock cover on the driver's door. Push up from the bottom hole while pulling out on the handle and it will pop out.
4. 2:45 Turn the backup door key in the lock cylinder to the left 5x quickly.
5. Follow the on screen instructions in the dash. It will say "Remote Learn Pending Please Wait".
6. After 10 minutes the instrument cluster will say "Press Engine Start Button to Learn". Press the power button once. It will say "Remote Learn Pending Please Wait".
7. Again - After 10 minutes the instrument cluster will say "Press Engine Start Button to Learn". Press the power button once. It will say "Remote Learn Pending Please Wait".
8. 3:33 After another 10 minutes the cluster will now say "Press Engine Start Button to Learn". Have your keys ready nearby. Press the start button. It will now say "Ready for Remote 1".
9. Place the first key in the center console. There will be a spot there in the shape of the key fob after removing the mat. When the key is in that spot press the power button. The screen will change to "Ready for Remote 2". Remove remote 1 and press the lock button and then the unlock button to sync the remote.
10. Place the next key in the center console and press the power button. The screen will change to "Ready for Remote 3". Press the lock and then unlock button on remote 2 to sync the remote.
11. 4:30 Continue with above until all remotes are programmed.
12. 5:00 When done programming remotes, press the power button down and hold it for 12 seconds to exit programming mode. I went a few seconds longer to be sure.
13. Reinstall the lock cylinder cover you removed earlier.
14. Have some refreshments! You just saved yourself a ton of money over the dealerships!
Check out my other Volt videos for more DIY and rebuilds!
16-19 Volt Oil Change - • DIY: 2016 - 2019 Chevy...
12 Volt Battery Change - • DIY: 2016 - 2019 Chevy...
Lighted Charge Port Install - • DIY: How To Install Li...
Change 5ET50 Drive Unit (Transmission) Fluid - • DIY: How To Change Tra...
Replace Cabin Air Filter - • DIY: How To Replace Ca...
Disable Pedestrian Noise Generator - • DIY: How To Disable Pe...
As an Amazon Associate I earn from qualifying purchases. I earn a small commission if you click my links and make a purchase at no additional cost to you.
#ChevyVolt #DIY #DuplicateKey