I thought about doing splitters exactly like this. The biggest issue is I couldn’t think of a way to make a proper leading edge so opted for a different technique. A quick tip for finding leaks, get a 2 foot section of the tube you use for infusion and put one end right near your ear and wave the other around the area of suspected leak and you should be able to pinpoint leaks.

@KrebsbachRacing

6 ай бұрын

I haven't figured out how to make a smooth transition either. I'm not an upholstery tech. Haha. I have yet to figure out a smooth way to wrap the edges or outside corners. Good tip for leaks though. Thanks!

the beautiful leaks in the vacuum seal =)

@KrebsbachRacing

6 ай бұрын

The enemy. Haha

Nice

압력확인을 안한채 수지를 넣어버렸군요

So cool and so close to that 1k subscriber. 🎉🎉🎉🎉🎉

@KrebsbachRacing

9 ай бұрын

Thanks! Almost there!

@autogeek23

6 ай бұрын

​@@KrebsbachRacing 1300!!!!

I have a composite shop and the bagging is the worst part and when you suck air that sucks as well. I use the thumb screw clamps and infuse a little slower a part that size takes me about a hour

@KrebsbachRacing

9 ай бұрын

yea I didn't mean to infuse that quick. Just lack of experience. haha

What's it weigh? Great video

@KrebsbachRacing

Ай бұрын

13lbs

Came from the professional awesome fb page! Thank you for the video! Very informative, eye opening to the DIY method! Off topic, who framed the shop area where you were working at?

@KrebsbachRacing

8 ай бұрын

Thanks! I built that as well.

Looked like you used Stretchlon 200 bagging film. Throw all of that away and use anything else. That stuff is garbage. I tried it 8 times and never got a single bag without holes, even on a flat piece. I used an ultrasonic leak detector and the bag had holes all over the place.

@KrebsbachRacing

6 ай бұрын

Good to know. Thanks.

Will you sell me one for my evo lol

@wurstcrewchief2798

9 ай бұрын

Same!!!