nice concise video to the point with no nonsense great stuff bought one

@tooloptics8651

Жыл бұрын

Thanks Thomas. I appreciate the feedback.

Excellent review. Thankyou.

@tooloptics8651

5 ай бұрын

My pleasure. Glad it was helpful

I bought it too. Thanks for the video

@tooloptics8651

Жыл бұрын

That's great. Thanks for the feedback.

I've had nothing but problems with mine, it just stops cutting all the time, I've stopped using it

@tooloptics8651

Жыл бұрын

Sorry to hear that Steve. Generally DeWalt are really good.

want to ask if someone know my dcs570 problem..why when i press the switch, firstly it working normally..but when i put it for about 10 minutes..and i press the switch again, its not working..and when i take off the battery, put it back to machine..its working again..for used it for break time not to long..it's ok..but if stop use about 10 minutes..that problem coming again and again..what should i do? sorry if my english not so good..im from malaysia

@tooloptics8651

5 ай бұрын

I haven't had that problem on my one. Does it cut off after 10 minutes of use. Do you think it could be overheating?

@Sapit-lq2oz

5 ай бұрын

@tooloptics8651 it's not overheating sir..just used it cutting about 3-5 seconds..and in 10 - 20 minutes used again..never overheating yet before..look like the sensor or anything like that

You didn’t mention, but you can see in your video at 2:43 the line guide notch at the front of the base plate is badly out…about 2mm. For machined metal parts this inaccuracy is dreadful….basically if you use the guide to follow a line your work piece will be 2mm wider than you wanted. It would not have cost DeWalt anything to just ensure it was correct huh!

@tooloptics8651

Жыл бұрын

Hi Contessa. I think the notch on the base plate you are referring to, is for when you are cutting at 45 degrees. So I think the accuracy of the base plate is pretty good. But thanks for the comment. 👍

@clemmcguinness1087

4 ай бұрын

Kerf?

@contessa.adella

12 күн бұрын

Put it another way….saw a line along a fence guide….then just back up (with power off) and see where the cut line comes at the front notches. The cut is a good 2-3 mm to the right of the notch. The second notch is for beveled cuts…probably well out too I’d imagine. Thanks for responding.

junk