So simple. So reliable So robust! One HUGE, short double roller chain. Easy to work on. NO BELT DRIVE OIL PUMP! Mine's in a 1988 P22 Air Force step van!

These engines were pretty ahead of their time. The cam and lifter set up is very similar to an LS.

@87cr250r

9 ай бұрын

I have heard the cam and lifters were supplied by Stanadyne. Forged steel and hardened. I just did a low buck rebuild on a GEP block for a CUCV and have a lifter knock now. I'm sad I tossed my 6.2 lifters. Now I have to buy an aftermarket lifter.

@tjs_welding_and_fabrication

9 ай бұрын

@@87cr250r are there any markings or numbers that indicate a standedyne lifter.

I have one in my 80 dually , They are the equivalent of a stock 350 chevy in power with better fuel economy ... They have an unwarranted bad reputation .. No turbo and they were on par with other diesels of the era as far as power was concerned ..They sound good like a diesel should .. not a lot of support for these anymore .. EIther people despise them or they love them like a reheaded stepchild ...

@MattsMadnessOfficial

Жыл бұрын

Not even close to a stock sbc these pigs made 130hp new and I think it was a bit overrated, I do love these engines dont get me wrong I still have 5 of them and drive 1 everyday, but a stock 305 will well outperform the 6.2 and a 350 is like 3 of these engines and would still prolly weigh less, the good thing about these engines they last forever and run used oil and you can drive them for free

@johngranata5515

Жыл бұрын

@@MattsMadnessOfficial The one i have has 160 hp and 275 lb torque ,, a similar 350 of 1980 had 180 hp and 275 lb torque ,, the diesel had all of its torque in by 2000 rpm the gas was higher in the rpm band ..

@rock-uu7qr

3 ай бұрын

@@MattsMadnessOfficial these things beat the 350 in terms of torque and economy.

@MattsMadnessOfficial

3 ай бұрын

@@rock-uu7qr fuel milage yes all day, torque not at all the stock 305 makes more torque and more hp

@rock-uu7qr

3 ай бұрын

@@MattsMadnessOfficial no heavy duty j code 6.2s made close to 300 ft/lbs @2000 rpm. Much more torque for doing work than a 350. Maybe not a vortec 350 but definitely a tbi

Also if you know its going to be bad you can pull the rocker shafts out so all valve are closed and adapt a grease jerk to the glow plug hole use a grease gun

I have heard the military versions hold up better than the normal ones. Is that true?

wet a rag with diesel let it burn out in the hole, do that a few times and it will come apart without tearing shit up

Where could I get a used '94 6.5L turbo intake manifold with EGR (or with EGR cover plate) pls?

@jonwallace7015

7 ай бұрын

From me

It is easy to swap the engine to a diesel from gasoline engine to into a diesel engine