Exactly what I needed thank you

Thanks for the tips !!

Whow it runs great at Idle in the End.. Low and not stalling.. It sounds so sweet. Regards J.

@Bataha

Жыл бұрын

Thank you

@CyrisrossCyrisratt

11 ай бұрын

@@Batahaaye bruh I have the same kind and I don’t know how to get it back running I’m just starting to get on quads

It runs amazing.. I Like that low idle when it not stops, but stay running at Low Idle Hope really to write with you Regards J.

Never had any luck with any stock chinese carb. until I fritzed with it to some degree.

Thanks for the Vid, I have the same exact 4x4 and had exaclty the same problem I ordered that carb and the only issue was with the throttle plunger inside does not fit too big for the new carbs cylinder? any ideas to check out? Thanks

Great job here

@Bataha

2 ай бұрын

Thank you.

when’s the new top speed test?

Hey I just bought a Coleman 200b By any chance you know why it rev it self and stay in high rev so when I change gear it kicks

Looking at the slide in the carb, doesn't look like it opens all the way, therefore it cuts airflow and defeats its purpose...also be mindful its air cooled so running a little richer would be a cooler engine so maybe maximum air would not be a good thing. Even stock, you could have opened the idle jet and raised the needle on the slide I would think....

@Bataha

6 ай бұрын

It opens all the way, 4:29. I agree with running it on the richer side. I messed with the stock one but you can't swap jets and I tried chaning needle height, thats why I upgraded.

Hay after you take off the air filter the stock one has a little rubber line that comes out and goes to inline fuel filter then in to the back of the motor when I chang the air filtter to one like you did were do you put that little hose back on

@Bataha

Жыл бұрын

2:09 I but a breather on the line.

@duwaynecouch9091

7 ай бұрын

Any pictures wondering the same what do I do with that line

I had the same issues. I installed everything you did in the video and it revs up and down at idle..I tried adjusting idle and air a bunch. Sometimes I throw it in neutral and it surges up to 5k+.. any idea?

@Bataha

6 ай бұрын

Adjust the needle height and see if it will run any better. Make sure nothing is clogging up the carburetor.

I'm doing the same thing. So, how did you adjust the throttle cable when you put on the new carb?

@Bataha

6 ай бұрын

adjust throttle cable for tightness? I didn't have to change anything

Bro how’d you add the new carburetor? I orders what you have listed and it was not compatible! The gas pedal line didn’t attack or fit yo anything. I’m ready to burn this atv to the ground 😢

@Bataha

6 ай бұрын

I'm sorry man, do you have the same 4-wheeler and have there been any mods to it?

I have the exact same quad and ordered the same parts as you but it idles really high in neutral and I have turned the idle control screw all the way to the right. How did you get it to idle low?

@Bataha

Жыл бұрын

turn the idle screw to the left to lower it.

@0991sirhc1

Жыл бұрын

@@Bataha Thank you

hello, did the performance increase or decrease when I installed the new carburetor?

@Bataha

10 ай бұрын

Increase, it is way better than the stock carburetor.

What did you gal the spark plug to?

@Bataha

6 ай бұрын

.030"

Wat happen it blew up after gaining more power?

@Bataha

6 ай бұрын

I bought it used and let it sit for awhile and couldn't start it again, because it lost compression, so I engine swapped it.

Will that all fit on the at125ex?

@Bataha

6 ай бұрын

Yes I'm pretty sure

Whats the carb you put on it? Amazon one?

@Bataha

Жыл бұрын

Yes, It's linked in the description.

What’s was the carb number

@Bataha

2 ай бұрын

PZ20 Carb: amzn.to/3QSO3d0

Top speed run ?

@Bataha

Жыл бұрын

The engine blew up before I could top speed test it

@jpena6812

4 ай бұрын

Why did it blow up?

@saltcreekraisedbarter4329

4 ай бұрын

Why did engine blow up