If you found the video helpful and would like to buy me a beer as a thanks,Links ⬇️ : 🙂REVOLUT: revolut.me/shirle4gny PAYPAL: paypal.me/washingmachinetips?locale.x=en_US

Fanastic advice. You fixed the problem . Top job buddy

@washingmachinetipsandhelp4350

4 ай бұрын

You are very welcome dude 😎👍

Brilliant. Thanks a lot. 🥰

@washingmachinetipsandhelp4350

3 ай бұрын

You are very welcome 🤗

Thank you so much. 👏👏👏

@washingmachinetipsandhelp4350

3 ай бұрын

You are very welcome 🤗

Hi. I have serie 4 with the RPM button, the door is open and there is water left in the drum. When trying to close the door and turning the machine on the door mechanism clicks a few times and then fails to lock the door and start. Any ideas on what to try?

@washingmachinetipsandhelp4350

Жыл бұрын

Hey, It sounds like the door lock may be the issue presuming there is no damage to the door itself?

Hi , how I can do to exit test mode E00 in bosch serie 4 ? Every time I switch-on the macchine appear E00 and it's does't work.

@washingmachinetipsandhelp4350

Жыл бұрын

Hi There, Did you try the reset in the video?

Hi, I have a Bosch Series 4 WKD28350GB which is a bit different from the one in the video. Do you know how to reset that one? The sequence in the video didn't work. Thanks!

@washingmachinetipsandhelp4350

Жыл бұрын

Hi, Unfortunately I don’t know the reset technique for that particular model of Machine. Are you getting any error code ?

@larslowesjosund2751

Жыл бұрын

@@washingmachinetipsandhelp4350 I'm getting a PUMP E06 error. If I run a Drain & Spin program right after getting it, then it drains fine and finishes without error. I followed the manual and checked the pump, which was empty, and the hose which wasn't bent and it seems like the water is flowing freely. Any ideas what might be the issue?

@washingmachinetipsandhelp4350

Жыл бұрын

@@larslowesjosund2751 I would suggest changing the pump but the fact that it is pumping out the water would suggest the pump is ok. It is very unusual. If you fill the drum (empty from clothes) to say 4-5 inches of water. Stop the machine. Put it to a spin and drain cycle, Is the water leaving the Machine at a very fast rate. ? If it is slow to leave it may suggest an obstruction in the black dump hose going from the the drum to the pump housing.

How do we set the hot water temperature on serie 4 please ? Really struggling

@danieloconnor6594

Ай бұрын

Just press the temperature button before starting the cycle to go through the different temperatures for the program select. Not every program has the same option but you can select 60 to 20 degree on most.

I have an E32 error, any ideas on what could fix it?

@washingmachinetipsandhelp4350

Жыл бұрын

Usually an uneven load. Try just doing a spin cycle and then retry doing a wash

Please help I can't get my series 4 to respond all the lights on the display are lit up .after unplugging it overnight it still won't respond

@washingmachinetipsandhelp4350

Жыл бұрын

Hi Lucy. Did you try the reset a couple of times? It sometimes takes numerous efforts for it to reset

Hi I had a blockage in pump which i removed but now machine now just beeps when I press start button

@washingmachinetipsandhelp4350

Жыл бұрын

John I only saw this, my apologies. Any luck ?

Hi I have a different style Bosche machine seems to be the same model number but has a different dial . we have to manually turn to spin after every cycle ! Not sure will a re set sort ? WAP28378GB

@washingmachinetipsandhelp4350

7 ай бұрын

Why do you have to put it on a separate spin after each cycle ?

@jamesgavin7111

7 ай бұрын

@@washingmachinetipsandhelp4350 hi thanks for the swift response , it will not automatically go into spin after every cycle , if we dont put to spin the clothes are too wet to take out

@washingmachinetipsandhelp4350

7 ай бұрын

@jamesgavin7111 no problem. It could be a draining out issue perhaps. It may be draining out the water but not at the correct pace. Did you check the filter and the pipe leading from the drum to the pump housing ?

@jamesgavin7111

7 ай бұрын

@@washingmachinetipsandhelp4350 Thanks will check now.

@washingmachinetipsandhelp4350

7 ай бұрын

@jamesgavin7111 no prob

My machine has e20 error followed by - 61 have knocked machine on and off at main and tried resetting this machine has never been used I don't know what else to do

@washingmachinetipsandhelp4350

11 ай бұрын

This is a heating issue (e20) it could be the element, Thermostat or Main PCB at fault. I’d contact Bosch direct if still in warranty.

Hi sir, My bosch cant end/ finished washing, after 00:02 minute, back again to normal ( 15:00) and still locked Can you help me to fix? Thank you

@washingmachinetipsandhelp4350

Жыл бұрын

Hi, Does the reset help at all

@fachrips9920

Жыл бұрын

@@washingmachinetipsandhelp4350 how to d o it?

@washingmachinetipsandhelp4350

Жыл бұрын

@@fachrips9920 copy the video

@fachrips9920

Жыл бұрын

@@washingmachinetipsandhelp4350 how to return it? Already to test mode

The key and anti wrinkle bottom stays on and 0:12 stays on my display. The Washington machine doet response on noting even when I pull the electricity off and the off button. Please help me😢

@washingmachinetipsandhelp4350

11 ай бұрын

Did you try keeping the start button pushed in for 5-10 seconds?

@washingmachinetipsandhelp4350

11 ай бұрын

If that does not work try this… Is it possible the Machine Got damp? What I would try (worth a try) is to dry the front of the machine with a hairdryer on full heat where all the bottom and dial are for at least 12-15 minutes spreading the heat evenly. Turn on the Machine and try it again

When I put it to the off button and turn the dial ot keeps saying 13

@washingmachinetipsandhelp4350

10 ай бұрын

Did you try the reset ?

Hi, thanks for the video. Is it mandatory to test all from P01 to P30 ? I was geting E29.

@washingmachinetipsandhelp4350

3 ай бұрын

Hi, as far as I can remember you can skip through

I am having trouble with this machine. Keeps saying 59 mins and the door key light is flashing

@washingmachinetipsandhelp4350

5 ай бұрын

Hi Mark, How are you ? Sounds like the child lock is on. Here is the link on how to remove it kzread.infoexY5Z9emcAo?si=3N9H3NgUaTv8sx8y

@wads1978

5 ай бұрын

Thank you. I think I have fixed it. Really appreciate your help. Mark

@washingmachinetipsandhelp4350

5 ай бұрын

@@wads1978 excellent! Nice one Mark 😎👌👍

How to fix f E:18 cannot open n it stop water cannot drain yet

@washingmachinetipsandhelp4350

Жыл бұрын

Did you check the filter ?

@sheirellcruz9596

Жыл бұрын

@@washingmachinetipsandhelp4350 not yet..

@DouglasWhitcomb

Ай бұрын

Did you solve it? I’m having the same issue. Checked the tubes (both black and grey one) and changed the pump with a brand new one. It works if I do the short rinse/spin program without any clothes inside but when I try with a longer program with clothes inside the E18 still pops up. Also can’t reset it. I can follow the instructions in the video just fine but when I turn it back on the display will not light up all at once (meaning the reset went through). After turning it back on it will basically act normally and not reset if you get what I mean. Any help is much appreciated. Many thanks.

The door lock stays on all the time

@washingmachinetipsandhelp4350

Жыл бұрын

Maybe you have inadvertently turned on the child lock? If Not perhaps a faulty door lock

Hi could you please explain it slowly. Since our model is Asian version i was unable to understand.

@washingmachinetipsandhelp4350

Жыл бұрын

Hi, unfortunately I do not have one of those Machines anymore to make a new video ☹️

Door lock stays on

@washingmachinetipsandhelp4350

Жыл бұрын

Can you open the door at all?

These machines are a poor offering from Bosch, seem to be plagued with faulty control units and memory. Every one of them has a fault code repeatedly showing and they can lock the door at random.

@washingmachinetipsandhelp4350

Ай бұрын

Agreed, They are absolute rubbish. And the cost of them is outrageous too