damn that wheel bearing was in pieces! good to know a press isn’t needed

@desilva68

Жыл бұрын

Yeah I was expecting problems getting this off, but it just fell off!

Impressive and great job. Thank you for sharing. On the to-do list besides replacing the shocks front and back.

@desilva68

2 жыл бұрын

Well its a 20 year old Z4, im sure your list is going to be as long as mine lol. I have been for a long drive today and I have a strange knocking noise from the front and I am starting to have that steering wander that other z4 owners have had. So its going to be a long week trying to work out whats happening !

@onnobeckerhof5790

2 жыл бұрын

@@desilva68 hope I can fix before something breaks while keeping budget in balance. One of my challenges is roadnoise. My previous Z4 had a lot less road noise but I cannot find the root cause yet. Insulated the wheel wells did help a lot but the noise stays. It's like constant noise entering the back of the car while driving on certain tarmac.

@desilva68

2 жыл бұрын

Maybe your rear bearings need changing or the rubber drive shaft coupling on prop shaft is at fault. There are some videos on that rubber coupling causing problems. Ebay this product code 26111225624

@onnobeckerhof5790

2 жыл бұрын

@@desilva68 regarding the knocking sound. I had that couple of weeks ago. It turned out that the air fan (for interior) was at fault. Garage fixed it under warranty. Regarding sounds my plan is to use an old Bluetooth headset and put it in some protective case. Except for the mic ofcourse. This will allow me to mount the case near a suspected issue and record the sound while driving. I hope I can figure out the root cause of the noise.

@desilva68

2 жыл бұрын

Sounds like a really good idea, of course let me know if you discover problem 👍 What year is your Z4 ?

No need to use the notch in nut when it's that tight lol and I see you don't trust the torque wrench

@desilva68

2 жыл бұрын

Torque wrench only went to 210Nm BMW says it should be 280Nm! But it hasnt fallen off yet🤣

@pereldh5741

2 жыл бұрын

@@desilva68 290Nm. I’d be sure to get that :)

Hey moe, this one don't go here, it goes on the other side, ok curley, why didn't you say that before I drove the sucker home, a well a nyuck, nyuck nyuck, a woo woo woo. Soytney.

@desilva68

Жыл бұрын

Tomato toe egg steel i say, glumk nak nak kabam!

Not a good video,

@desilva68

2 ай бұрын

Not a good comment and tough. You make a video.

@JohnBarnes-vm7jo

2 ай бұрын

@@desilva68 take my words as good advice, not criticisisum.

@desilva68

2 ай бұрын

You didnt give me any advice! You just criticised my video🥴 but thanks for watchin 👍

Change the front wheel bearing and the bit you don't show is taking of the wheel bearing. Pretty pointless.

@desilva68

Жыл бұрын

That was because the wheel bearing just fell off! I didnt have to put any effort into pulling it. So pretty pointless? I think it shows how piss easy the job was to do! But thanks for your useless comment! If you had read the description i quite clearly state that it just fell off!!!