Great help on set-up man. I've just got into 1/10 & run a Destiny rx10sr & going through set-up like you've shown. Only question is when I measure droop the front right at it's lowest is 5 but front left is 6? I can't take it any lower as adjusting screw is already flush with chassis. So I've made front right 6 to at least be even. Rear is fine & can go as low as 5 but have that at 6 also. Would there be a reason for this. No accidents & chassis is not tweaked! cheers
@connorreeve9076
4 жыл бұрын
Sounds like could be an issue with the shockes want to cheap that they are all the same length
@michaelbelby802
4 жыл бұрын
Sorry for the late reply, often this can be from different shock lengths. Make sure when you build your shocks you measure the length and adjust the bottom mount until they are even. There is a great CornerSpeed RC tool for this that I use. If your car is tweaked (twisted) this will also cause uneven results. Always hard to tell without seeing the car. Show someone at your local club and ask for help if you can't sort it out.
@therealraulgarcia4 жыл бұрын
what spur and pinion do you recommend for 17.5 motor?
@michaelbelby802
4 жыл бұрын
Sorry, I don't race 17.5. ask at your local track for advice
@Azzooooooo
3 жыл бұрын
@@michaelbelby802 what you use for 4.5t?
@djanubi4 жыл бұрын
The last part of your explanation is a bit wrong ! When one wheel is lifting off the ground faster than the other you untighten the spring on the same side and other end of the car and tighten the opposite spring(on the other end of the car) to not change the overall ride height of the model! Verify this with Martin Hudy explaining the same basically as you did here!
@teoshuhaw9413 жыл бұрын
This one RC can use 3s?🤔
@michaelbelby802
3 жыл бұрын
These cars are designed for 2s. Some of the speed Run guys modify the car to use 3s or more but racing is 2s
@teoshuhaw941
3 жыл бұрын
@@michaelbelby802 but this rc play 2s..Speed like a 3s right?
@michaelbelby802
3 жыл бұрын
It's all about the motor. My modified 4.5t with boosted timing goes about 100km/h. Don't need to go that fast on the track though. Too short most of the time. Slower classes use a 21.5 or 13.5 with no timing. Still very fast to manoeuvre around a race track
Пікірлер: 16
Thanks For Sharing Mate!
Great help on set-up man. I've just got into 1/10 & run a Destiny rx10sr & going through set-up like you've shown. Only question is when I measure droop the front right at it's lowest is 5 but front left is 6? I can't take it any lower as adjusting screw is already flush with chassis. So I've made front right 6 to at least be even. Rear is fine & can go as low as 5 but have that at 6 also. Would there be a reason for this. No accidents & chassis is not tweaked! cheers
@connorreeve9076
4 жыл бұрын
Sounds like could be an issue with the shockes want to cheap that they are all the same length
@michaelbelby802
4 жыл бұрын
Sorry for the late reply, often this can be from different shock lengths. Make sure when you build your shocks you measure the length and adjust the bottom mount until they are even. There is a great CornerSpeed RC tool for this that I use. If your car is tweaked (twisted) this will also cause uneven results. Always hard to tell without seeing the car. Show someone at your local club and ask for help if you can't sort it out.
what spur and pinion do you recommend for 17.5 motor?
@michaelbelby802
4 жыл бұрын
Sorry, I don't race 17.5. ask at your local track for advice
@Azzooooooo
3 жыл бұрын
@@michaelbelby802 what you use for 4.5t?
The last part of your explanation is a bit wrong ! When one wheel is lifting off the ground faster than the other you untighten the spring on the same side and other end of the car and tighten the opposite spring(on the other end of the car) to not change the overall ride height of the model! Verify this with Martin Hudy explaining the same basically as you did here!
This one RC can use 3s?🤔
@michaelbelby802
3 жыл бұрын
These cars are designed for 2s. Some of the speed Run guys modify the car to use 3s or more but racing is 2s
@teoshuhaw941
3 жыл бұрын
@@michaelbelby802 but this rc play 2s..Speed like a 3s right?
@michaelbelby802
3 жыл бұрын
It's all about the motor. My modified 4.5t with boosted timing goes about 100km/h. Don't need to go that fast on the track though. Too short most of the time. Slower classes use a 21.5 or 13.5 with no timing. Still very fast to manoeuvre around a race track
@teoshuhaw941
3 жыл бұрын
@@michaelbelby802 know it.. thx bro..👌
Where are you based mate
@michaelbelby802
5 жыл бұрын
Australia. Gold Coast 😁
@Azzooooooo
3 жыл бұрын
@@michaelbelby802 yo I'm from aus also!