Thank you sir!!! I was finally able to set the timer on my Fujitsu thermostat. Apparently the contractor I used to do the installation didn’t think that my hard earned 17k that I paid him was enough for them to teach me how to properly use this equipment. I was left with instructions binder but most of the pages are covered in blood. I guess I wasn’t worthy of receiving a sanitary free instruction binder. Well anyhow after coming home to a cold room also many latex gloves disposed of after hours of reading the instructions on this unit.... you my friend were able to help me in just 2 minutes. Thank you Caleb!!
@elioliban10 ай бұрын
Hi , I purchased a Fujitsu split system two years ago, and it came with this thermostat. As you demonstrated, you need to use a light to be able to see!!, which is ridiculous. There's no backlight! I was very disappointed, I thought they sent me an old technology (back when the television was in black and white!),so I contacted both my vendor and Fujitsu, and they confirmed that this is the correct thermostat. Therefore, I'm interested in replacing the UTY-RNNUM with a wifi-enabled one. Could you recommend a compatible replacement? Thank you!
@timjustice2293 жыл бұрын
1. Thanks for the video 2. Thanks for the music
@germswill3 жыл бұрын
What thermostat would you recommend if I’d like to be able to control the AC from my phone remotely?
@Misakyanovich6 жыл бұрын
So when it's super hot outside, I have to set my mode to snowflake? What do I do with temperature and fan speed ?
@ShogunHART15 күн бұрын
How can you get through the operation prohibited? I have a Simple Remote Controller UTY-RSRY and can’t change the sensor to enable. The manual is useless. Any advice would be appreciated.
@snookers14333 жыл бұрын
What do the buttons w the arrows pointing in different directions mean?
@dudelebowski4832 жыл бұрын
Here is my take for the best cost and comfort. I live in the San Francisco Bay Area and it’s mid November. I Put my qty 3 min-split’s on “Auto” and “Econ” setting the temp to 68F. That seems to work w little complaints and is easy on the electric $.
@johnharrisonschulz7 ай бұрын
When would I have to set the unit number? I have two air handlers connected to my Fujitsu outdoor heat pump. Both wired controllers are set to unit number 00. When would I have to set them differently? Main reason why I'm asking is, I installed a UTY-TTRXZ1 thermostat converter and everything is installed correctly, but the air handler does not come on. I'm wondering if I have to change the unit number using the old Fujitsu wired controller prior to installing the converter and a standard thermostat.
@mariamarias16305 жыл бұрын
Thank you so much, i ve been struggling for a while with my machine hahahha
@videos102 жыл бұрын
Does this thermostat not have current indoor temperature ?
@Rodador246 жыл бұрын
Is that the Great Jazz Trio playing Nardis?
@robertproctor57292 жыл бұрын
Hi how do you remove panel as it has gone yellow and would like a new cover
@mrfabian185Ай бұрын
Thanks 🙏🏻
@sharifsharif16193 жыл бұрын
Well, I have a question and general, why does it stop after 3 minutes, what else can be the problem, I want to go, and the fan coil shuts down, why?
@TrueVixion2 жыл бұрын
Thank you so much. I was suffering from the wrong settings being on.
@gonzalomanzaneda76334 жыл бұрын
Thanks a lot for the video! Do you know if its possible to set the ac the same way but for two different time periods? I would like to active the ac in the morning stop it during the day and turn it on again during the evening. Thanks in advance!
@UberAV
2 жыл бұрын
I don't know. You're welcome from behind.
@suemount646 жыл бұрын
Can you tell me if this is supposed to have a LCD backlight? It's so hard to see we have to use a flashlight to see the settings!
@petegolomb3591
6 жыл бұрын
No, it is not backlit. They should have included a flashlight with this model since one can only read the dial under ideal light conditions. This model also doesn't show the room temperature. The model that is backlit and shows the room temperature is UTY_RVNUM.
@kwhite145
3 жыл бұрын
@@petegolomb3591 No backlight sucks
@fishski941
3 жыл бұрын
@@petegolomb3591 thanks for the info. Hard to believe they didn’t include two of the most basic functions found on just about every electronic thermostat made in the last 20 years.
@verygood123 жыл бұрын
Anybody knows how to change the date, time and day of the week in this thermostat?
@dudelebowski483
2 жыл бұрын
Yes, hold down top left button labeled “clock adjust” on the bottom of the button. U should be able to figure it out from there to set both time and day. The confusing part is the same top left button says “timer mode” don’t pay attn to that 😎
@helaine80646 жыл бұрын
this is very clear except that I don't understand how to set the temperature during programming. For example, if I want the unit to come on at 6:30 a.m., how do I program at what temperature?
@ellendouglass5220
6 жыл бұрын
I would like to do the same on our unit, so that we can set the timer for the unit to start and stop at certain times of the day. Please help if anyone knows how to do this.
@sahiljuned3762 Жыл бұрын
Hi sir i need maximum temperature change setting have possible??
@roroiboni74014 жыл бұрын
Thanks dude
@johnjohn-cs9eu6 жыл бұрын
Anyone know why key symbol. If its "locked" how do l unlock?
@lyramaravilla9849
10 ай бұрын
I’m having the same issue currently!
@videos102 жыл бұрын
How come it doesn't say current temperature ?
@bra2il2 жыл бұрын
Dpes anyone know if these panels can be controlled via IR remote???? , and if so whats the model name? Thanks
@USA-GreedyMenOfNoIntegrity
2 жыл бұрын
You use one or the other to control your mini split.
@johnjohn-cs9eu6 жыл бұрын
H e l p ... l cn see the obvious functions but cannot get out of key symbol /feature/function
@menenilesh248226 күн бұрын
How to change farenhit to celsious? Please tell about this
@CarlosEmilioPujalsKury6 жыл бұрын
is there a way to factory reset the control?
@aadilmehmood30592 жыл бұрын
helo sir plese one video make the o general duct ac remove er cod in thermostate
Пікірлер: 46
Thank you sir!!! I was finally able to set the timer on my Fujitsu thermostat. Apparently the contractor I used to do the installation didn’t think that my hard earned 17k that I paid him was enough for them to teach me how to properly use this equipment. I was left with instructions binder but most of the pages are covered in blood. I guess I wasn’t worthy of receiving a sanitary free instruction binder. Well anyhow after coming home to a cold room also many latex gloves disposed of after hours of reading the instructions on this unit.... you my friend were able to help me in just 2 minutes. Thank you Caleb!!
Hi , I purchased a Fujitsu split system two years ago, and it came with this thermostat. As you demonstrated, you need to use a light to be able to see!!, which is ridiculous. There's no backlight! I was very disappointed, I thought they sent me an old technology (back when the television was in black and white!),so I contacted both my vendor and Fujitsu, and they confirmed that this is the correct thermostat. Therefore, I'm interested in replacing the UTY-RNNUM with a wifi-enabled one. Could you recommend a compatible replacement? Thank you!
1. Thanks for the video 2. Thanks for the music
What thermostat would you recommend if I’d like to be able to control the AC from my phone remotely?
So when it's super hot outside, I have to set my mode to snowflake? What do I do with temperature and fan speed ?
How can you get through the operation prohibited? I have a Simple Remote Controller UTY-RSRY and can’t change the sensor to enable. The manual is useless. Any advice would be appreciated.
What do the buttons w the arrows pointing in different directions mean?
Here is my take for the best cost and comfort. I live in the San Francisco Bay Area and it’s mid November. I Put my qty 3 min-split’s on “Auto” and “Econ” setting the temp to 68F. That seems to work w little complaints and is easy on the electric $.
When would I have to set the unit number? I have two air handlers connected to my Fujitsu outdoor heat pump. Both wired controllers are set to unit number 00. When would I have to set them differently? Main reason why I'm asking is, I installed a UTY-TTRXZ1 thermostat converter and everything is installed correctly, but the air handler does not come on. I'm wondering if I have to change the unit number using the old Fujitsu wired controller prior to installing the converter and a standard thermostat.
Thank you so much, i ve been struggling for a while with my machine hahahha
Does this thermostat not have current indoor temperature ?
Is that the Great Jazz Trio playing Nardis?
Hi how do you remove panel as it has gone yellow and would like a new cover
Thanks 🙏🏻
Well, I have a question and general, why does it stop after 3 minutes, what else can be the problem, I want to go, and the fan coil shuts down, why?
Thank you so much. I was suffering from the wrong settings being on.
Thanks a lot for the video! Do you know if its possible to set the ac the same way but for two different time periods? I would like to active the ac in the morning stop it during the day and turn it on again during the evening. Thanks in advance!
@UberAV
2 жыл бұрын
I don't know. You're welcome from behind.
Can you tell me if this is supposed to have a LCD backlight? It's so hard to see we have to use a flashlight to see the settings!
@petegolomb3591
6 жыл бұрын
No, it is not backlit. They should have included a flashlight with this model since one can only read the dial under ideal light conditions. This model also doesn't show the room temperature. The model that is backlit and shows the room temperature is UTY_RVNUM.
@kwhite145
3 жыл бұрын
@@petegolomb3591 No backlight sucks
@fishski941
3 жыл бұрын
@@petegolomb3591 thanks for the info. Hard to believe they didn’t include two of the most basic functions found on just about every electronic thermostat made in the last 20 years.
Anybody knows how to change the date, time and day of the week in this thermostat?
@dudelebowski483
2 жыл бұрын
Yes, hold down top left button labeled “clock adjust” on the bottom of the button. U should be able to figure it out from there to set both time and day. The confusing part is the same top left button says “timer mode” don’t pay attn to that 😎
this is very clear except that I don't understand how to set the temperature during programming. For example, if I want the unit to come on at 6:30 a.m., how do I program at what temperature?
@ellendouglass5220
6 жыл бұрын
I would like to do the same on our unit, so that we can set the timer for the unit to start and stop at certain times of the day. Please help if anyone knows how to do this.
Hi sir i need maximum temperature change setting have possible??
Thanks dude
Anyone know why key symbol. If its "locked" how do l unlock?
@lyramaravilla9849
10 ай бұрын
I’m having the same issue currently!
How come it doesn't say current temperature ?
Dpes anyone know if these panels can be controlled via IR remote???? , and if so whats the model name? Thanks
@USA-GreedyMenOfNoIntegrity
2 жыл бұрын
You use one or the other to control your mini split.
H e l p ... l cn see the obvious functions but cannot get out of key symbol /feature/function
How to change farenhit to celsious? Please tell about this
is there a way to factory reset the control?
helo sir plese one video make the o general duct ac remove er cod in thermostate
What if there is no symbol or turn on
Como cambiar la pila
How to panal
What problem Er error code
@ranadanish648
4 жыл бұрын
Plz helm me
En español pofabor
No entiendo el idioma
En français svp
How do I program limits on the min and max temp?