Wow dude genius... That drill bit drops into the slot you cut previously.. Thank you so much for this video, And The board in the middle separating👍
@theorangelamp Жыл бұрын
I've watched A LOT of videos recently to understand how to make the cuts in the stiles for the louvers. This is by far the best one! Much simpler looking jig than most I've seen and the most ingenious part is that the jig allows you to make the cuts mirroring each other so they always line up. So many videos and my own trial and error has 1/32" off and it throws each cut off, so by the time you get to the end, everything is noticeably not aligned. Thank you for sharing! I had one question: what is between the two stiles? It's the gray-ish piece between the two pieces of wood you're cutting. It appears pre-cut. Can you describe what it is and it's purpose? Thank you again!
@woodbe5311
Жыл бұрын
Hi Anna. Thank you for your comment. the piece in between is a MDF strip with the thiknes of the router bit i was using. 12 mm to be more precise. That alow the transition of the angle without demage the outher piece. I made a lote of louvers with this process and went so well. Now i use a CNC router for that propose.
@theorangelamp
Жыл бұрын
@@woodbe5311 Thank you so much for the information! I'm going to give this a try! It's a very excellent design.
Пікірлер: 4
Wow dude genius... That drill bit drops into the slot you cut previously.. Thank you so much for this video, And The board in the middle separating👍
I've watched A LOT of videos recently to understand how to make the cuts in the stiles for the louvers. This is by far the best one! Much simpler looking jig than most I've seen and the most ingenious part is that the jig allows you to make the cuts mirroring each other so they always line up. So many videos and my own trial and error has 1/32" off and it throws each cut off, so by the time you get to the end, everything is noticeably not aligned. Thank you for sharing! I had one question: what is between the two stiles? It's the gray-ish piece between the two pieces of wood you're cutting. It appears pre-cut. Can you describe what it is and it's purpose? Thank you again!
@woodbe5311
Жыл бұрын
Hi Anna. Thank you for your comment. the piece in between is a MDF strip with the thiknes of the router bit i was using. 12 mm to be more precise. That alow the transition of the angle without demage the outher piece. I made a lote of louvers with this process and went so well. Now i use a CNC router for that propose.
@theorangelamp
Жыл бұрын
@@woodbe5311 Thank you so much for the information! I'm going to give this a try! It's a very excellent design.