9. Orkney Strikeliner 16+ Now afloat! Tour of the boat at anchor in Wareham Channel, Poole Harbour.

After several months of hard work in the boatyard, Lady Wimborne is now newly renovated, seaworthy again and ready to be used out on the water. One of the first test runs is a short 6 mile round trip up the Wareham Channel and back. It’s a beautiful sunny day and I drop the anchor just off Arne in Poole Harbour and give a quick tour of the boat. There’s a fair bit of wash as water ski and wake boarders are being towed around nearby. This is the area of Poole Harbour where water skiing and wakeboarding is allowed in the designated area.

Пікірлер: 10

  • @ct026
    @ct026 Жыл бұрын

    Lovely set up, you should be proud. Stay safe. 👍🏻👊🏻

  • @alexstubbins6298
    @alexstubbins6298 Жыл бұрын

    Great to see her on the water. Good job man

  • @eprohoda
    @eprohoda Жыл бұрын

    ommg!stunning , man-

  • @tessilateddragon
    @tessilateddragon Жыл бұрын

    Very nice set up ..... I run a 590 out of christchurch, i'll keep an eye out for ya..... tight lines.

  • @georgehunton
    @georgehunton Жыл бұрын

    Hello, Where did you find the tall stainless rail at the stern? All the best, George

  • @mattryland949

    @mattryland949

    Жыл бұрын

    Hi George, The rail came with the boat when I bought it so I’m afraid I’ve no idea where it’s from. Matt

  • @congerman
    @congerman Жыл бұрын

    Hi, great boat. I have just purchased one but only get 9knts with 20hp 4stk merc. Could you tell me your prop pitch pease?

  • @mattryland949

    @mattryland949

    Жыл бұрын

    Hi, The boat came with an 11 x 9 prop but I could only get about 4800rpm at Wide Open Throttle (WOT) and a top speed of 12 knots with just me on board. I swapped it for a slightly larger diameter 9.8 x 9 prop. So that’s 0.8 inches extra diameter but 2 inches less pitch. Now I get 5800-5900 rpm at WOT and that’s nicely within the 5000-6000rpm range the outboard manual says you need. The highest speed I’ve had is 15-16 Knots with just me on board. The 25hp is a 3 cylinder so will produce more torque than a 2 cylinder 20hp so I’d say yours might need a slightly smaller diameter prop than mine. You could try a 9 x 9 perhaps. Getting the outboard into the correct rev range is most important as the top speed varies so much depending on weight, weight distribution, wind and tide. With 4 people on board I only get 6 knots and yesterday I went out on my own and only got 14 knots as there was a bit of wind. I generally cruise around at 4000rpm which gives me about 8 knots on my own or 6 knots with 4 people on board. Hope this helps, Matt

  • @congerman

    @congerman

    Жыл бұрын

    @@mattryland949 Thank you

  • @zebulenplacke5183
    @zebulenplacke5183 Жыл бұрын

    𝓅𝓇o𝓂o𝓈𝓂 🏃

Келесі