Shop this MotoFab Front and Rear Leveling Kit! : amtrucks.at/3Pr1sIM

Good job thanks

@AmericanTrucksChevyGMC

Жыл бұрын

Thanks for watching! -Zach

My RST 275/60-20s are 33s and is stock height. I’m running Falken all terrains and there’s no run. Also I thought a 2in front would level it so I’m confused about a 2.5 front and 2 in rear. Lastly the trail boss has a different CV axle design because its design to go from its 2in lift over std heights to 2in plus. Reason this is important is that if you lift more than /in on a stock base height Silverado the are CVs will not last long if you are using your truck off-road heavily.

I have this kit on my truck, note that your rear shocks will be too short, and will limit downward travel causing the rear tires to loose contact with the ground on big bumps. You can add a shock extension if your shocks are new, or I ordered bilstein 5100s for a trailboss, and they fit perfectly. Also, in front I found it easier to loosen the sway bar link out of the control arm rather than out of the sway bar, and you should take the drive axle nut off the allow the stud to slide in the hole 😉. That will keep pressure off of the drive axle and keep from ripping a boot.

@Inkd_dad

8 ай бұрын

How have your components like cv shafts held up??

@Dumbass_mechanic

8 ай бұрын

@@Inkd_dad 30,000 miles in with 0 problems.

@Inkd_dad

8 ай бұрын

Thank you for getting back to me. Just ordered this kit and plan to do Bilteins and new upper control arms.

@Dumbass_mechanic

8 ай бұрын

@Inkd_dad I have stock upper control arms and the angle is perfect. This kit sets you half an inch taller than a stock trail boss in front. Trailboss uses the same stock control arms, so you shouldn't need control arms to correct the ball joint angle. If you're going to add bilsteins in front, then get the ones that are longer and provide lift, then you won't need to add this kit in front. I did bilsteins in back because I had shock adapters and didn't like the ride, and also they kept coming loose and making noise, so I put on 5100s for a trail boss, and they work perfectly and improved the ride. I still have the stock struts and springs in front with this kit on them.

@Inkd_dad

8 ай бұрын

@@Dumbass_mechanic thank you again. This is the information I was looking for. I will probably do just as you recommend.

Great job!!!😅 thanks

@AmericanTrucksChevyGMC

11 ай бұрын

Thanks for watching! -Zach

So for that plastic wire bracket on top it just requires been pryed up? Nothing to unscrew?

Could I put 305/70R18 tires on it with 0mm offset on the wheels and do this lift?

Anything for a 2021 Chevrolet Silverado custom trail boss with the 6.2

2.5 inch lift in front and 2 inches in the back equals level INTERESTING ✌️🇨🇦

@Fpv___

Жыл бұрын

I think there is still alittle rake with this lift. I read another review where a guy said he needed only 1 inch block in back for level but it might depend on trim package.

@gk9417

Жыл бұрын

@@Fpv___ ya you might have to do more adjustments to get it the way you like it Keep it up until your happy For some reason it’s never is what it claims ✌️🇨🇦

@Dumbass_mechanic

8 ай бұрын

Not quite level, still up a little in the back, but close to level. I use my truck as a truck and like the little bit of height in back. It sits level with the camper hitched up.

@jimjohnson3307

8 ай бұрын

It comes out level, I put 33x12.50x20s on and works great.

How long of bolts in the bottom

Where do I find all the factory torque specs?

Will this work for a 2019 GM Sierra 5.3L? Thank you for the video

@mr_diddlz001

8 ай бұрын

Yes

Does the kit come with install instruction and torque specs for each bolt removed?

@harrisonvanhoozer1152

Жыл бұрын

Factory torque specs.

Does it manufacture recommend an alignment afterwards?

@shupster369

Жыл бұрын

Always when lifting or lowering your vehicle

@Dumbass_mechanic

8 ай бұрын

I aligned mine. It's what I do for a living. We didn't need to move caster or camber, but we did need to toe out a bit.

Would this work with my 5’lift kit I have in my Silverado I have a lifted strut, but I can double stack the rear blocks?

@AmericanTrucksChevyGMC

Жыл бұрын

We don't recommend stacking blocks. The lift kit you currently have may also have tolerances to the 5 inches that wouldn't work well with the 2-2.5" addition.

@Dumbass_mechanic

8 ай бұрын

Never stack lifts

I just installed this kit in my 2021 GMC Sierra 1500 Elevation X31 Double Cab. And after the installation the front wheels lost their alignment and I feel vibrations when accelerating from 0 to 30 mph, and when braking and slowing down to full stop. The installer said that it's because the suspension needs to settle down, I have to come back after 100miles and they will tighten up the bolts, they said vobration should go away, not sure this is the case. I'm concerned the drive shaft or ball joints are is at an agle that causes vibration wearing out the U joints prematurely. Also the ride is stiffer, rear shoks were extended and when going on bumps the suspension travel gets to the flly extended positon and the wheel jumps having an uncomfortable hit at the back of the truck. I called I might remove this kit if the issues continue in the next few weeks. For the missalignment, the installer said he is not responsible for it! America Trucks should cover it. Will seewhat happens, if I don't get all these issues soted out I will remove this kit. Not worth compromising the ride quality.

@joelthomas4294

Жыл бұрын

recommended that you get a wheel alignment after leveling installation

@Inkd_dad

8 ай бұрын

I'd like kno know the out come of this.

@32:35 "so with the U bolts all tightened up , and fastened to factory spec" (i e rammed on with a air gun, so it must be tight enough) LOL .. I saw no torque wrench anywhere.

Do they fit on 2019 chevrolet trail boss custom 1500 4x4??

Anybody know the wheel/tire size in the after shots? I want this look!

What size tires on on the truck in the video?

@richardj.bejarano4121

Жыл бұрын

33 tire the wheel probably a 17 thats why they look so big.

Can you do a video for trail boss models?

@mr_diddlz001

8 ай бұрын

If you rewatch it. You can see it up on the screen and her say this is excluded from the AT4 AND Trailboss models. Meaning they cannot be installed on those trims

@Dumbass_mechanic

8 ай бұрын

Trailboss is already 2 inch lifted all the way around via blocks in the rear and longer struts in front.

Can I put this lift your 2 1/2 inch or 33 inch tires for the thing is my Chevy Silverado what’s a 2023 2.7 L four-cylinder please let me know if that is bad idea please let me know.

@Dumbass_mechanic

8 ай бұрын

It'll work

I ordered this kit, what size wheels and tires are in this video

@Dumbass_mechanic

8 ай бұрын

You can fit 33x12.5r18 on a stock truck with no lift, on stock wheels. some say they've put 35s on with this kit, it may or may not rub. My 33s look tiny

Might not be a bad time to hit all that orange stuff with some Fluid Film while you're under there.

Would this work with me having a food truck and pulling it 4-5 times a week? And not have a bad lean when pulling

@Dumbass_mechanic

8 ай бұрын

How far does your truck sag with the trailer on it now?

@xstablishedtv

8 ай бұрын

@@Dumbass_mechanic at the moment not at all

@Dumbass_mechanic

8 ай бұрын

@@xstablishedtv it'd work fine then. You may need to get a longer drop hitch to compensate for the extra 2 inches of bumper height and keep your trailer level.

@xstablishedtv

8 ай бұрын

@@Dumbass_mechanic got ya! Thank you! I really appreciate it!!

Any need to upgrade the UCAs with this kit?

@AmericanTrucksChevyGMC

11 ай бұрын

I'd recommend doing it if you have room in your budget! It'll lead to your truck handling better and correcting geometry angles after the leveling kit is installed. -Zach

@yardwhisperer

11 ай бұрын

@@AmericanTrucksChevyGMC thanks!

@Dumbass_mechanic

8 ай бұрын

I didn't and my truck handles like a dream and the angles are perfect

My silverado came with 33s from the factory…

This is not correct, you need to turn the strut 180 degrees for spring to run like designed! This guy is stress the strut lower rubber not recommended…..

@arkedin2759

4 ай бұрын

You have to turn the strut 180 degrees to even get it in and mount it. So he did that

@aaroncastro7157

4 ай бұрын

How turn 180 degrees….????

@reececofer9219

3 ай бұрын

You don’t have to turn it 180 if your strong enough to turn the bushing

@arkedin2759

3 ай бұрын

@@reececofer9219 wrong.

look at all that GM rust 🙄, I hope GM fixed that problem in the new Silverados. My friend have 2005 Tundra and it's looks better than that silverado

@Boobtube.

8 ай бұрын

different parts of country produce different amounts of rust. You have no clue where this trucks been.

@ronnyfen2406

8 ай бұрын

@@Boobtube. I am in the Caribbean 100 meter next to the sea my cousin mazda have no rust.

@ronnyfen2406

8 ай бұрын

Btw i have a Silverado Duramax ml2 love it, Just sent it to the dealer check engine light in a 1 year old 7500Miles truck.

@Boobtube.

8 ай бұрын

@@ronnyfen2406 ok, so you have no idea what the snow belt areas do to ALL vehicles from the salt put down to clear the roads. Your only comparing your environment instead of the rest of the world. If that mazda was driven in the snow belt, it to would be long gone and in the junk yard or crushed as scrap long ago.

@Boobtube.

8 ай бұрын

@@ronnyfen2406 keep us abreast on what it was.