► Oil Filter Friday, watch a New Automotive oil filter inspection video every Friday on this KZread channel.

Love your New England accent.

@WhipCityWrencher

9 ай бұрын

Thanks😊👍

great video! it looks easy when somebody else is doing all the hard work. LOL!

@WhipCityWrencher

2 жыл бұрын

🤣 Thanks, bud

Morning Whip ! Another good video from ya, Sir. You made it look easy enough! 👍 An advantage of living in Texas is we don’t use road salt that causes some of the rest on the vehicles, it does up in your part of the world! Wishing you and Yours a Happy and Blessed Thanksgiving !! Stay Safe Buddy!

@WhipCityWrencher

2 жыл бұрын

Thank You! Yep, as far as salt goes you guys are lucky. That salt does a number on our vehicles. Thank you for the Thanksgiving blessing🙏 and may you and your family have a Happy Thanksgiving also. Take Care!😊🙌

Well that looked easy enough...👍👍

@WhipCityWrencher

2 жыл бұрын

Yep, Not too hard, Thanks for the feedback👍

Good tutorial on how to install this. Very good. :)

@SimpleTastyFood2024

2 жыл бұрын

@@WhipCityWrencher I'll pass the message to Ella. Happy Thanksgiving to you also. :)

@SimpleTastyFood2024

2 жыл бұрын

@@WhipCityWrencher Happy Thanksgiving and You're welcome. Merri :)

@WhipCityWrencher

2 жыл бұрын

@@SimpleTastyFood2024 oops I did it again, I'll get it one of these days. Thanks Merri, Happy Thanksgiving to you also😊

@SimpleTastyFood2024

2 жыл бұрын

@@WhipCityWrencher No problem. I'm actually instant messaging Ela now and told her about your Thanksgiving wishes to the both of them. They just went to 99 and had a wonderful meal with friends. Take care. :)

@WhipCityWrencher

2 жыл бұрын

@@SimpleTastyFood2024 Thanks😊

Thanks for the video! I have a question. How were you able to diagnose that the control arm went bad? I have a clunking noise on my drivers side whenever i accelerate. I can't tell which part went bad.

@WhipCityWrencher

7 ай бұрын

Thanks for asking, I wish I would have shown that in the video. It would make a loud squeaking /metal noise on that side when you rocked the front end up and down. Your problem might be the CV axle joint. "I don't know"

@Souls-iq8to

7 ай бұрын

@WhipCityWrencher ah ok, well, thanks for the reply

I tried this and the new part was too tight to fit into the rear end position. Insanely tight. I was thinking of grinding the top a little. Any tips for this? Thanks.

@WhipCityWrencher

8 ай бұрын

Try taking a tire iron or crowbar and stick it in there and pry it open a little bit, just a little. Let me know if that helps.

Nice 👍

@WhipCityWrencher

2 жыл бұрын

Thanks, drum😊

Your control arm has been replaced before I had to use a bolt breaker drill to get mine out

@WhipCityWrencher

2 ай бұрын

I don't know, not my Jeep, but it wasn't that old.

@davidplays6286

2 ай бұрын

@@WhipCityWrencher ah but the impact shouldn't have worked someone was their before