This video literally helped fix a lot of stress, wife just got back from a trip and heater stopped working, with your video I was able to get it fixed . Thanks for the content

Man I’ve never left a KZread comment in my life but I’ve just tested every relay and fuse -related and unrelated, and gone down every possible rabbit hole of why my heat and ac aren’t working just hoping I wouldn’t have to pull the dash out but here I am 3 hours and and 6 beers deep and your video just helped me confirm exactly what part I need to get this working again! Whacked the actuator while changing from cool to heat and watched the cam move and finally the heat kicked on. Can’t wait to go buy a new actuator and get this fixed, thank you!

@Zazu309

5 ай бұрын

Happy to help! Cheers 🍻

Watched your video and my f-150 had the same exact issue. Literally a 15 minute fix because it took me 10 minutes to find my 1/4" wrench...

This is the driver’s side temp control. The passenger side temp control is on top of the heater box directly above the driver’s side control actuator.

Great video, thank you for sharing this! Also, thanks for putting the part number on the video too! Saved me a lot of time and money!

Thanks! Best video I've found on doing this.

Thanks man. Got my heat going. My first attempt I just had hot and less hot. I definitely recommend holding the actuator there in its correct spot and testing before screwing back in the torx screws. Reaching up in the hole the actuator covered and manually moving the blend door to heat and setting the actuator to heat(plugged in but not installed) made it install right and work for me. The white cam piece came off with the actuator for me so it made installation pretty confusing and allowed me to install it wrong on first try.

You are correct. The driver side controls the direction and passenger controls the temperature. I lost the temperature control a month before I lost the direction control. Replaced the directional one and it wasn’t too bad. The temp control leaves it really hot or cold. No in between at all. This will be the next one. Thanks for the video!

Just replaced mine. Thanks for the guidance! Definitely requires some patience.

Thanks for the help. I have the exact same problem. Hopefully it will work for me. I appreciate the clear illustrations. Thanks again

Thank you very much for this video. You saved me thousands

Thanks for the video man totally fixed my truck too

Dude thank you. Having the same issue sometimes it’s stuck on cold sometimes it’s stuck on heat. Was about to tear into the dash rather than the passenger side.

To make diagnosing which door you need to replace simpler, a mode door actuator controls the flow position, i.e. floor, vent, defrost. a blend door actuator changes the temperature, cold to hot and vise versa. a recirc door actuator will change between fresh air and recirculated air. also, a recirc door actuator will almost always be very close to the blower motor itself.

@wolbiman

Жыл бұрын

Where is the recirc door actuator located?

Thank god for this video. You're the best.

Awesome video. Really appreciate this to save a ton of $$

2016 F150 3.5 Turbo Lariat was not blowing air cold or hot through dash and defrost vents. Used this video and not being short or small enough I also removed the driver's seat 4x 13mm to make more room. Fantastic fix can not thank you enough.

@rafacordero8862

28 күн бұрын

Mine only blows through defrost I can't change it to go through dash vents What you think it's the problem

@houston3332

2 күн бұрын

@@rafacordero8862 kzread.info/dash/bejne/Y46NpdKlhJbIlNo.html he mentions it at this timestamp. If the vents aren't switching between face/floor/defrost then it's likely the driver side actuator. FL3Z-19E616-A part number. I have the same problem as yours and I'm hoping that's the fix.

Thanks for posting this video!

Your video and another couple I found a really helped me. I found that that white cog is actually broken in mind. Guess I need to order that

Awesome video. I had no AC...fixed the problem. Except my screw head was a T15 on my 2016 XLT 5.0 Thanks

@Zazu309

5 ай бұрын

lol The things they change between different models 🤔. Glad you were able to get it fixed!

Thanks for the video you saved me a ton of money! And your voice is hot

Thank you I almost spent 1k

Great video! Thank you so much!

Great information I'm about to change the driver side one. Glad to know if my heat stops that will be my first stop. $1000 😂😂😂 thats what i was told came home KZreadd the problem 30 min. And $25 later problem solved. These people are criminals.

I had no air coming out of the defrost. Changed the gas pedal side acuator and now I only have air coming out of the defrost and big vents. Anyone know how to fix this? Reset of sone sort.

So if my issue is that the passenger side is hot and drivers side is cold then I need to replace the one behind that passenger air vent you mentioned?

@Zazu309

Жыл бұрын

Yes I believe so, if you have the dual zone control feature then I believe your culprit would be the actuator behind the middle vent inside the dash. It's much more difficult to access but it is possible and I have seen some videos that walk you through it. Good luck!

@nolanclark2253

Жыл бұрын

@@Zazu309 so I actually completed this fix yesterday and it ended up being the same one you replaced. Which I was relieved about and did not have to go through the vent.

@Zazu309

Жыл бұрын

That's great to hear!

my issue is the exact opposite to yours ....mine has the heat going on rather than cold ...ill assume that its the same actuator....i do not have the dual temp control...mine is like yours....do you think that this is the only one that could be defective ....crossing fingers...let me know what you think...much appreciated sir

@Zazu309

Ай бұрын

I would venture to say yes, it's probably the same actuator that's the problem. It just got stuck in the heat position, rather than the cold. Hopefully, you'll be able to get it figured out.

I have the same symptoms you describe, I'm hoping this is my problem. So, how do you test the actuator to know that's the issue?

@mikekelly8158

Жыл бұрын

I think I see how to test it now. I'll check out to see if that white piece rotates to determine if it's actually broken. Thanks for the video

@Zazu309

Жыл бұрын

Yea getting eye's on that white mechanism is your best bet. Hopefully you get it figured out 🤞

Under the floor board?

@Zazu309

Жыл бұрын

Did I say floorboard?.... oops, I obviously meant dashboard 🤦🏻‍♂️

Is it also the same for 2013 f 150?

@Zazu309

Ай бұрын

Unfortunately I can't answer that question. I'd imagine it's a similar setup though. The actuators might just be in slightly different locations. Sorry I can't be a better help

Thank you very much sir. This was extremely helpful.

I just broke the mount for the top of the white piece

@Zazu309

6 ай бұрын

That sucks..... not sure what part you'll need or how difficult that'll be to fix, but good luck

Mine is just blowing from defrost not from dash vents Wich one you think it is Its a F150 2016 King ranch If you can help me please🙏🏽

@Zazu309

28 күн бұрын

It sounds like yours is most likely the actuator on the driver side. Assuming you don't have the zone AC feature?

@rafacordero8862

28 күн бұрын

The AC is ok working good just not blowing from dash so It's taking for ever to get cold inside

@Zazu309

28 күн бұрын

Yeah I would check the actuator on the Driver side. I believe it is fairly accessible from under the dash just above the pedals.

@rafacordero8862

28 күн бұрын

@@Zazu309 Thank you very much I will

How do u calibrate this parts?

@Zazu309

9 ай бұрын

"Calibration" I'm not too sure of. I was told, however, if you turn the temp control knob all the way to either temp and then just adjust the white cam until it aligns correctly. Hopefully that helps...

@richardballard748

7 ай бұрын

I replaced the mode door actuator this summer. It wasn’t easy and getting it to the correct position took a lot of trial and error. Today the blender door broke. At least it’s stuck on hot. It’s December. This looks a a little easier I hope. I did purchase the bumper to bumper extended warranty so I might check with the dealer. These broke within a year of each other. Obviously cheap design.

@Zazu309

7 ай бұрын

That's a shame.... hopefully it can be covered. Just don't pay $1,000 to fix it lol

Thank you

Who the hell in their right mind would pay one thousand dollars to have this work done???