Very nice video! Extremely helpful for maintenance on my Mercedes!

thank you so much for this video, it help me out a lot

Thank you, with this video I did the Job on the street...took me like 8 hours...alott of connectors and hoses,bolts and screws...but job is done

Thank you for adding the audio this helps a lot. there are some that don't. You might not have planned this but this is a good how to video, Well done.

Thanks for the video! Indy tech in a shop. Got it done without a problem. Except book time was 1.6 hrs according to alldata. once i saw this,i was able to adjust accordingly

@JimFab202

Жыл бұрын

Glad it helped!

I have this exact same car just having a little trouble finding the coolant temp sensor , any ideas ?

What seals did you have to replace on this job

Top video

Do you have to remove all that to access the Coolant Temp Sensor?

Do you have a video about how to change the water pump? Or can I get in touch with you ‘cause I have a big question on how to reinstall the pump. I really need help, hope you can give me a hand.

What was the torque spec for the intake?

Thanks so much, I have been trying to get to the Throttle body on my Mercedes and was afraid to do something wrong, with this video I believe I can tackle the job now. Also can you tell me why is it that most engines in the US are so dusty?

@jonsnow2555

Жыл бұрын

Could be in the south west of the U.S. it's a big desert there

👍👍👏👏

How did you diagnose that it was the thermostat that needed to be replaced?

@JimFab202

3 жыл бұрын

Zero to 60 in 3 a code set for thermostat below threst.

Hello! Is it need to change only thermostat? Or also intake manifold and some tubes or metal pipes? Just only thermostat? Does it need to clean intake manifold?

@JimFab202

3 жыл бұрын

When replacing thermostat you need to replace all gaskets of components that get removed. Always clean parts that get reinstalled.

I changed the thermostat on my c300 after the scanner showed was the thermostat and it keeps overheating. What’s could be a possible solution?

@JimFab202

2 жыл бұрын

Possible solutions can be a faulty water pump, cooling fans not operating properly, faulty temperature sensor and or computers.

Hey do you know where coolant temperature sensor is ?

@raeshniroula8221

10 ай бұрын

Hi Did you get answer for this? I couldn’t find where is the coolant temperature sensor for this car

My c200 2016 is not blowing hot air and is overheating, the tempetrature sky rockets when i was driving the other day. Could it be the thermostat?

@JimFab202

4 ай бұрын

It could be a numerous amount of things, best to get a proper diagnostic done to it and pinpoint what exactly it needs.

Good afternoon what was your torque wrench set at for nm at 19:36 mark of the video?

@JimFab202

3 жыл бұрын

Eric Rios can’t remember exactly but somewhere around the neighborhood of 9-12Nm

@ericrios9904

3 жыл бұрын

@@JimFab202 would you happen to be able to point me towards the direction of finding that info ? Thank you

@JimFab202

3 жыл бұрын

Eric Rios will most likely have to be either a source like AllData or Mitchel on demand for accurate information

Did you have to replace the manifold seals ?

@JimFab202

Ай бұрын

Yes

What about the coolant temp sensor???? And for those of you doing timing dont get me started on that oil pressure sensor switch that the wire goes through the bottom of the timing cover and if you aren’t careful you can break the plug the harness and or sensor itself Now Ask me how i know lmfao … it would be nice if there was a timing video on this engine with this year c300 275.1

What was the mileage of the car and were the intake valves heavily soiled?

@JimFab202

Жыл бұрын

At the time of this repair, the vehicles mileage was somewhere around 60k miles and no heavy carbon build up on valves was noted.

@jejeanmarie4167

Жыл бұрын

This video was very helpful it took my Certify mechanic 5 hours and half but the job was done thank you again he didn't watch the video but I did

@jonsnow2555

Жыл бұрын

​@Je Jeanmarie how much $?

Where is the coolant temperature sensor? Please answer

@JimFab202

10 ай бұрын

Coolant Temperature sensor is located on the thermostat assembly, as shown on this video.

how much is to do something like this???

@JimFab202

3 жыл бұрын

With parts and labor you’re looking at somewhere around $800-$1100 out here in california.

@williepeters1258

2 жыл бұрын

$800 for a thermostat on a new car,?? Doesn't make sense"

@badboy17pt

Ай бұрын

​@williepeters1258 it's the labour not the parts I got quoted 1400 in the UK 12h but the oil valve also needs doing wich is just by the thermostat

A lot involved for just RR thermostat.

لو منزل مكينه كان احسن 😂😂

Omg so difficult compared to domestic or Asian car all that for thermostat ridiculous!!!

@johnfrisk2375

Жыл бұрын

Everything is so easy to get too just the problem is you would have to take apart most of it to get to that one thing.

What a piss poor design!!

trash cars