Just downloaded the service manual and it says "Do not screw the dipstick in when checking the oil level". Page 88.

Don't screw the dipstick to check the oil level. From the owners manual (the service manual will say the same). To check the engine oil level 1. Park the vehicle on a level surface. 2. Remove the console. (See page 8-9 for console removal and installation procedures.) 3. Check the engine oil level on a cold engine. If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least ten minutes until the oil settles for an accurate reading. 4. Remove the engine oil filler cap and wipe off the dipstick with a clean rag. 5. Insert the dipstick in the oil filler hole (without screwing it in), and then remove it again to check the oil level. The engine oil should be between the minimum and maximum level marks. 1. Maximum level mark 2. Minimum level mark 3. Dipstick 4. Engine oil filler cap 6. If the engine oil is at or below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level.

@frankchodacki6269

8 жыл бұрын

+frank chodacki .. that is.. don't screw the dipstick IN.. ;-)

Thanks for this - just got a 2006 Rhino 660 and needed to know how to check/fill oil.

I just bought a rhino and I was looking for the damn thing... thank you for this video.

What kind of jack-leg engineer hides the dip stick under 2 seats and a console?

@xtronkillmaster2517

4 жыл бұрын

100% agree. I couldn’t find the damn thing, that’s what led me to this video.

Does all 450 rhino have oil cooler systems

Uhhhhh, never known an engine that had a screw in dipstick that you screwed it back in to check the oil. Always unscrew, wipe clean, then just set back in the port. You are running your engine pretty low on oil!!!!!

Where do you add the oil if low?

@D.I.Y._All-in-One

9 жыл бұрын

Roc Villeneuve fill in same place you check it . you will need a funnel.