No video
2001 Ford F250 Door Panel and Door Lock Actuator Replacement
The door power locks would work sometimes but not all the time. I got 2 new ones so lets get them installed.
Here is my store thegautomotive...
This video was made as a demonstration on how to repair things and should not be done with out the proper training and safety equipment. The G Automotive and More and Its affiliates are not responsible for any damage or personal injury. Please if you don't have the ability to do these demonstrations, don't try and get a professional to do it for you.
Пікірлер: 9
Just finished replacing my latch on my 02 F350. Couldn't have done it without this. Thank you!
This video did not help me to disassemble the lock mechanism. Another KZread video showed how to do the process better by dismantling the exterior door latch.
@TheGAutomotiveAndMore
Жыл бұрын
I just rewatched the video, seems to explain everything pretty good to me. It is hard to show everything in side the door.
@edholland7
Жыл бұрын
@@TheGAutomotiveAndMore When I did the disassembly, I was not able to undo the green clip that holds the threaded rod in place. I looked at another video, and that guy removed two 7mm nuts holding the exterior door latch to the door. The rod and green clip were then easily accessible. Suggest you revise your video to show this option. The rest of your video was great !!!! ED
@buckblaster9550
11 ай бұрын
I have to do both doors thanks for the video looks like it's going to be a bit of a pain but I'm happy that there isn't 20 clips that break everytime on the door panels
@GregoryT-u5j
11 күн бұрын
@@edholland7 I replaced two actuators before. Now I need to replace the other two. I didn't think to check KZread the first time, but this video is exactly how I figured it out. But yeah, that green clip is a booger, because you can only get in that space with one hand. That clip was the hardest part of the entire job and took the longest to figure out. You have to pry where his figure is at 8:58 and the clip swings open. Update: I see what you mean, now that I've taken the driver's door pa0nel off. I have a 2000, and the door cutouts aren't the same. I will have to go in through the outside door handle. Update 2: 11mm nut. One is behind the rubber plug, above the Torx screws, 5:24. Peep inside the cutout to see the other one. Don't drop the nut inside the door. Also, make sure the cable to the actuator is on the correct side of the manual door lock. 5:24 is a good picture of what I'm talking about. You will have to take everything apart if the cable is on the wrong side of the rod. And of course, that's when it starts to rain.
You can get the actuator off without removing the latch.
@TheGAutomotiveAndMore
7 ай бұрын
I tried, it would not come off. Had to remove it.