Пікірлер

• 
  @rikardbjork3491Ай бұрын

  Cant get it work.. left door

• 
  @michaelgriesbach50172 ай бұрын

  There is a cotter pin on the large spring of the Bowden cable that holds the spring back. Does this cotter pin have to be removed after installing the window regulator mechanism?

• 
  @quattro49442 ай бұрын

  Does it have to bo even on that roll ?

• 
  @TheWahab20022 ай бұрын

  Bro the video quality is so bad I couldn't even see what he did. Also we're the first comments since this was uploaded which was 11 years ago so I doubt he'll respond

• 
  @quattro49442 ай бұрын

  @@TheWahab2002 :d after spending few hours yesterday to rewind that wire in scirocco window regulator i finally gave up and ordered replacement:d

• 
  @Fernando-fgc19643 ай бұрын

  y se debe soltar al final la chapita blanca que retiene el muelle para que quede tenso total

• 
  @cirrhosas62143 ай бұрын

  Gros merci ça m'a super aidé pour refaire mon lève vitre

• 
  @paulsthormes2513 ай бұрын

  Not easy it took me hour and a half not fun glad it's finished.

• 
  @user-ej9cm6sj2o3 ай бұрын

  be careful as this is not the left door on a RHD car. Process is correct bur check cables are connectedin relation to the feet of the runners. I also had to adjust the sheath lenth on the longest cable to get enough slack to work

• 
  @andrewhirst30534 ай бұрын

  Are you sure this is correct as I can’t get the spool back in as you show as there are two springs in the white housings that slot into the motor plate. Am I missing something?

• 
  @user-kx5nc9iw9q5 ай бұрын

  Great videos

• 
  @marvstoreАй бұрын

  Glad you like them!

• 
  @zolika19926 ай бұрын

  Right hand ?

• 
  @nicolasmansilla166 ай бұрын

  Alguien sabe las medidas de los cables??

• 
  @AliEkiz-uj2gj8 ай бұрын

  Good men

• 
  @guillermopeacerivers-kd7bc11 ай бұрын

  Un completo lio. Por 10€ más comprar uno nuevo o de segunda montado

• 
  @oguzhancetin_mech Жыл бұрын

  I cannot fit in the cable it is too short what can I do about it

• 
  @huwrowlands7486 Жыл бұрын

  Mate I have tried this part 4:08 about 20 times it keeps piping out of place when I put it up to the metal bit to put it on god knows why could you please add me on face book or anything and tell me what I’m doing wrong

• 
  @selcukcebeciii Жыл бұрын

  Thanks for video

• 
  @edwin3143 Жыл бұрын

  Y

• 
  @mikeyphillips5565 Жыл бұрын

  It’s sad this is the only video that could help us and u didn’t even say a single word that’s great haha

• 
  @wahidcirta2534 Жыл бұрын

  👍👍👍👍🎉🎉🎉

• 
  @fatihayar365 Жыл бұрын

  Thanks 🙏🏻🙏🏻🙏🏻

• 
  @user-sx9ws9bh3e Жыл бұрын

  Спасибо этому видео !!!! Я три дня голову ломал

• 
  @user-tq6jm3qk6x Жыл бұрын

  Пружинок не поставили)))) как и я ))))

• 
  @aur1ga2 жыл бұрын

  походу гимор еще тот!у меня порвался трос-то что на видео это непонятка полная!

• 
  @walidmans60932 жыл бұрын

  Hi, I have same problem for my car do you can fixed?

• 
  @mduwhite81772 жыл бұрын

  Is this the same as the jetta 3 passat

• 
  @marvstore2 жыл бұрын

  Hi, This repair kit work applies to Passat B5 and B5.5 cars only

• 
  @patrickteater33922 жыл бұрын

  this is not the "left" side window regulator - this is the right side assembly! I have been looking at this video and comparing it against assemblies I have in stock and when I assembled one using the rails you have pictured it ends up being the passenger side and not the driver side! I assembled a driver side using this video and the whole mechanism is backwards! You need to reshoot this video with the correct rails! :(

• 
  @natalialiendro89472 жыл бұрын

  jb

• 
  @johnhealy20012 жыл бұрын

  Hello there were was the repair wire's bought my 407 coupe is the same design so would like to have a spare just in case thanks John

• 
  @MRM-wp4gr2 жыл бұрын

  It's much easier to just buy a new motor with regulator for $50 that is ready to be attached to the window

• 
  @ronnymcfarland77752 жыл бұрын

  You must be German

• 
  @alissonmauro53492 жыл бұрын

  Thanks! But you forgot the springs man

• 
  @alexe6103 жыл бұрын

  Merci beaucoup pour vos vidéos. à la suite des opérations ( avec qqs erreurs de manipulation ) sur lève-vitre Xsara Picasso, j'entends un bruit de relais ( à côté de la portière) et puis impossible à démarrer. Qqn a une idée d'où cela provient et où se trouve le relais? Merci

• 
  @rachidsafi61953 жыл бұрын

  What bout 307cc

• 
  @garybrion19533 жыл бұрын

  Ok, I did get there, Can I just add at the final point of getting the wheel on its mount with both wires tight and in their groves, you will need to turn it over and rotate it at the same time, rotate to tighten wires.Helpful vid thanks

• 
  @tomkerich5483 жыл бұрын

  Great video, no hello you tubers BS, Just a simple step by step instructional video. Thank you for that. The other video that came up when researching this, had a guy that just talked way too much and represented his channel heavily. (which isn't bad, I just wasn't in the mood for all that extra pep) I appreciate you for making this video. Thank You..

• 
  @daron89823 жыл бұрын

  should have filmed a bit longer

• 
  @harrypotter-bu9kj3 жыл бұрын

  Hello , how to remove rope fitting from the slot?

• 
  @VitorMadeira3 жыл бұрын

  Precious video. Thank you. Greetings from Portugal.

• 
  @Aynal-kz7yr3 жыл бұрын

  Danke ☺

• 
  @aaronmoore31293 жыл бұрын

  Do you have any regulators for the 306 cab? Front and rear?

• 
  @HARDEEPJADEJA3 жыл бұрын

  Hello, what to do if wire is broken ? And motor is working fine ?

• 
  @davorfulldavorfull3 жыл бұрын

  Hello Where can i buy a front right window cable by Peugeot 306 1996 Cabrio Please tell me Thank you advance

• 
  @jijisherazad18443 жыл бұрын

  Hello and thank you for your video but I do not see how you fix the white strip, I mean in what direction because on your film we do not see sufficiently this level. Can you at help me so I know how to fix it? Thank you

• 
  @saiko-play77073 жыл бұрын

  На кой перчатки со бля хирург что ли

• 
  @callumconnis95233 жыл бұрын

  This seems back to front

• 
  @izetkavazovic27644 жыл бұрын

  Thanks,this is very useful video ,now I can do it myself.

• 
  @yakubo60254 жыл бұрын

  2 mistakes 1. The metal bar with the 3 plastik clips Have to be on the back site so the 2 holes for the screw look at you 2. The short side hast to be wrapped an the other side

• 
  @arogio19944 жыл бұрын

  its right window regulator(passenger), not left...

• 
  @cseszkolaci3 ай бұрын

  exactly this fu.....ing video shows the right side

• 
  @patrickteater33924 жыл бұрын

  The link you have in the description comes up with an error message - do you have another supplier for the driver side regulator repair kit?

• 
  @xnetcascais4 жыл бұрын

  the video is ok, but no information how to slide the glass back into position :D