Awsum information mate thank you

Thanks bud!! Followed your instructions to the T and my drone is back in action w/ zero problems. Your video was straight to the point. 👍

@ledgeradan9495

2 жыл бұрын

I dont mean to be off topic but does any of you know of a way to log back into an instagram account? I was stupid forgot the account password. I would love any tips you can offer me.

@jadbrayden5154

2 жыл бұрын

@Ledger Adan instablaster =)

@ledgeradan9495

2 жыл бұрын

@Jad Brayden i really appreciate your reply. I got to the site on google and Im trying it out now. I see it takes a while so I will get back to you later when my account password hopefully is recovered.

@ledgeradan9495

2 жыл бұрын

@Jad Brayden it did the trick and I finally got access to my account again. I am so happy! Thanks so much, you really help me out :D

@jadbrayden5154

2 жыл бұрын

@Ledger Adan no problem :D

I am in the middle of replacing the flex cable of the camera yaw . One of the 3 small screws that connects it to the bottom of the drone got wasted. Any advice?

@Droneted

3 күн бұрын

If the gimbal has never been removed from the drone, one of the screws has glue in the center of the screw and you have to pick it out with a pointed object like a needle. If it is damaged I use an ez out tool.

Have you noticed on a Phantom 4 that after installing an aftermarket yaw motor, it appears to work fine, but now there's no camera feed showing on the controller? This just happened to me, and I have not had time to investigate it yet, but thought I'd reach out for an idea of where I need to start looking for the problem.

@Droneted

8 ай бұрын

Probably not the yaw motor. It is probably the ribbon cable. Do you have a camera sensor error?

@jaymay306

8 ай бұрын

@@Droneted the yaw motor was physically damaged after a hard landing / rollover, as it was explained to me, and hanging loosely. While the drone had a working camera feed, the gimbal didn't work correctly due to the damage. Now the motor is fixed, but the feed is gone. I'll check for error messages when I get home from work and turn it on.

@Droneted

8 ай бұрын

Ok. I’m here to help

Have you ever replaced the pitch motor, mine when it is perfectly level it will flip part way down and then back level again about every 5-10 seconds , but if you lower camera about 10 degrees it works perfect

@Droneted

3 жыл бұрын

Yes. That motor is a direct replacement. Very easy. Direct swap

@PhantomHodgesDrone

3 жыл бұрын

@@Droneted thank you

Can I send a video? It is hard to explain. When I first turn my p4p on it seems to start caging then the roll gimbal vibrates then roll travels from limit to limit and yaw travels back and fourth. I replaced the roll motor and ribbon cable twice, no help.

@Droneted

2 жыл бұрын

yes you can. droneted@gmail.com

Hey Ted, I have a P4 Pro V2 that has a yaw motor that has a dragging or scratchy sound when moved side to side and also has a very bad vibration. The vibration creates a jello effect in video and a not so sharp photo. Would replacing the yaw motor be the appropriate fix and if so where would you suggest I purchase one from. Thanks

@Droneted

3 жыл бұрын

It is possible that it is a bad yaw motor, or it could have dirt in it. try blowing it out with air first. It is also possible that the cap over the yaw motor is hitting . It is held on by just 2 Phillips screws ( PH00 screw driver) try just taking that off first. You can tell if that is an issue by moving the yaw back and forth with your hand while the unit is off. It should move very freely. Any binding at all is an issue.

@davidb7619

3 жыл бұрын

@@Droneted Well Ted I thank you for your reply. I took the gimbal apart and inspected everything. I didn't notice anything really wrong. I noticed after reassembly that if I grabbed the gimbal and pulled forward a bit the vibration would go away until it was moved. So I took a hard look at the vibration dampener. Seemed to look fine but for kicks I swapped the rubber dampeners front to back and flipped them upside down. Reassembled and powered on and haven't had a bit of vibration or noise what so ever. I went ahead and ordered and new dampener just in case but after a few flights now I have not had any issues again.

@Droneted

3 жыл бұрын

@@davidb7619 that can happen but it is rare. Glade you got it solved

Hello, Is is very nice what you do. I've learned a lot from watching your clips. Something I'd like to share with you. I had the pointing to the left problem with the camera. Replaced the Yaw motor as you did in this clip. All worked out with the switching the Yaw motor to the original magnetic case. To my disappointment. Still have the same problem. Any suggestions?

@Droneted

Жыл бұрын

I want to be sure I understand the issue. The gimbal pointed to the left. It did not swing back and forth. You changed the yaw motor and used the original case. It still points left as before. Is it steady and the only issue is that it points left? Did it start doing this all of a sudden or was there a crash or hard landing involved?

@corbettsantanavideographer364

Жыл бұрын

Hey @@Droneted - First thanks for getting back to me on this. Started with a crash. After that Started pointing left. Original case used. After repair, camera is steady as before but still points still to the left. 🔧

@Droneted

Жыл бұрын

@@corbettsantanavideographer364 if nothing is bent I would guess it may be the camera IMU. You can email me at droneted@gmail.com Are you in the USA?

@corbettsantanavideographer364

Жыл бұрын

@@Droneted Am located in Berlin Germany. IMU? What can I do to adjust this or fix it? Consider sending to you for repair. Depending on the cost.The ones I've met here are incompetent.

@Droneted

Жыл бұрын

@@corbettsantanavideographer364 You certainly can do that. The last time I shipped to Europe it cost about $50. If you wanted to ship it to me I can either repair it or swap for a refurbished unit. I suggest you email me at droneted@gmail.com to discuss the cost

I need the link that motor

@Droneted

Ай бұрын

www.ebay.com/itm/255599530976?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=MpO6DztRRhm&sssrc=2047675&ssuid=htIxleKGSaC&widget_ver=artemis&media=COPY

Can I send my drone to you to fix it and how much does it cost?

@Droneted

2 жыл бұрын

Your drone or your gimbal? email me at droneted@gmail.com It would have to be very soon or in August

@Droneted

Жыл бұрын

Cost depends on the issue.