I like the E-TEC!

@lukedaniels1731

5 жыл бұрын

haha wait till you own one, and it shits out on you 20 miles offshore. These are such shit motors, theres two dealers in my area who stopped selling them and went to yamaha instead

@jlo13800

3 жыл бұрын

@@lukedaniels1731 Lets see a 4 joke survive on just oil injection. i have both a 2 stroke small block v8 and 8v92 2 stroke on klotz techniplate synthetic 2 stroke oil, but its 46$ a gal but i dont mind!

@ganerboss900

2 жыл бұрын

They are good engines, especially G2 s ... Many technicians don't like them....

The best money can buy

@jimquantic

10 ай бұрын

and now they quite making them....?????

I like 2 strokes.

@gohogs2277

4 жыл бұрын

African Twin Hell yeah

Without watching the video, I was told by a dealer that when buying the old generation motor, go for 250 instead of 300, because 300 wrecks the fuel economy, but with the G2, go for 300. I'm happy with my G2, besides the power steering, which once was stuck on, overdrawing the charging system and causing the charging system protection to shut the engine down at random with no fault codes, and now there is a fault code 214, with no power steering at all the next time it was in the water after being serviced, and the engine sometimes stalls less than 10 seconds after startup but runs normally, neutral to full throttle. Other than those problems, the engine runs and performs just fine. It looks cool in my opinion and sounds menacing at idle.

At 16:47 the entire video starts over again.

im looking at a 2017 pontoon with etec 250 is it a reliable engine and does it use much oil

They are good motors e-tec OMC should have managed the company better and BRP should have kept the e-tec best built outboard ever. Beter than any 4 stroke ever. Never own a 4 stroke. Ever only had 2 strokes.

this is no G2

Evinrude better get it together or they're going be a memory. A lot of people seem like they're having problems with this engine.

@morteparla6926

5 жыл бұрын

Who? I know a few guys who run new ETECS and ETEC G2's without issue.

@brandonmurphy4657

4 жыл бұрын

They are now not making them anymore they are done...

@upurnose46

2 жыл бұрын

You called it, Evinrude is done lol

@jimquantic

2 жыл бұрын

@@morteparla6926 Many comments from people who own them--that's who.

@SF-rl7hl

Ай бұрын

That's a known lie the Evinrude e tac are very reliable outboards!

Come on people change the title or remove the video... the failure to do so shows how little you care about your work and the accuracy of your information.....what a joke, and yes they are an awesome engine as I have one!!!!!!!!!!!!!!!!

@george14756

5 жыл бұрын

Blake Love you sound upset!!!

ironic. we are fighting with our 2013 that has been in the shop more then on the water..

@polygamous1

8 жыл бұрын

+Thomas Mack from an owner will always come the best opinion, unless you just been very unlucky? but spending that kind of money u deserve better

@howabouthetruth2157

8 жыл бұрын

+Thomas Mack THANK YOU. Although I hate to see good people get taken on such an expensive investment, only to experience more expense & headaches due to dealer & manufacturer HYPE. I've been trying to tell folks for years now, to stay away from these E-tec engines because EVERY time I go to the boat place to buy things for my boat or have any work done to it, I see MORE brand new E-tec motors sitting there, that have FAILED, than all the other brands COMBINED. In 2004, I sold my old boat with Evinrude & bought a new boat with new 115 Yamaha 2 stroke with old-school carbs, and haven't looked back since. That motor never gave me the first problem, and even when it was due to replace the impeller, the old one still had plenty of service life left. My mechanic tried to talk me into waiting, but since he had it torn down, I requested he replace it anyway. To this day, over 11 years later, it still has great compression and the magneto's are firing like new. Ya just can't beat the durability & reliability of a Yamaha outboard......at least in my own personal experience & that of many other boat owners too.

@fast442olds

8 жыл бұрын

+Howabouthetruth YOU ARE FULL OF SHIT

@ThomasMack87

8 жыл бұрын

DAVE BICKHAUS what? go away

@mainaazakthar3724

8 жыл бұрын

you are right

this video should be removed

@george14756

5 жыл бұрын

morrgan haack etec is junk

@jlo13800

3 жыл бұрын

@@george14756 Lets see a 4 joke run with just oil injection and no oil changes.

What a stupid title

@Mirageman0373

8 жыл бұрын

+Beulah Lips that is a etec for u

Thanks I'm definitely not buying one of these anchors

This is a gen1 etec.

Click bait title is click baity

@drewmiller337

8 жыл бұрын

DaBrute would be Exellent at cinemasins lol

yeah, you should buy an etec if you're not too worried about having your expensive injectors/starter motor/ECM going bad because of bad quality. the trim button on the engine on mine also malfunctioned out at sea tilting the engine up at full rpm. the neutral gear switch also failed once limiting me to 1500rpm while far out. then there is the horrible smell from the e-tec oil....

@jlo13800

3 жыл бұрын

I run etec oil in my kohler mower 2 stroke conversion, it burns way cleanr than 10w30. Both my small block v8 2 stroke and 8v92 2 stroke are on klotz techniplate synthetic 2 stroke oil! motule 800 2t and silkolene pro 2 sx are way too muck. I had a 69 caddy coupe deville 2 stroke and ran fine on pennzoil tcw3 filled and premixed! a 2 stroke chevy looks like this:www.4btswaps.com/attachments/2cyclesbc-jpg.6839/

@jlo13800

3 жыл бұрын

I got got my toro kohler on xd-100 and not much if any smoke at all. Im on 40:1 though as its rigged with homemade oil injection!

It's 2018 and Evinrude is still mixing oil with gas. We have 4 of these and every one of them has had catastrophic failures. None have made it to 500 hours before needing to be replaced. I say no thanks.

@AB-bg1or

6 жыл бұрын

Ok. See above. The fact that it is injected didn't help the replacement of the motors or lower units. Over $16,000 a piece. Research it.

@gulag_dt

2 жыл бұрын

@@AB-bg1or but i still love the innovation that they gave 2strokes so sad that the problems outshined the positives

@jejoko

2 жыл бұрын

Up to 575 on my G1 with no problems yet. Not sure if you are referring to the G2 (title on this video is incorrect) Maintenance is key. Although the say 300 hours. I flush it regularly with barnicle buster, keep the gear oil fresh, clean the injectors and use Yamaha Ring Free every 3rd or 4th tank.

@AB-bg1or

2 жыл бұрын

@@jejoko they were G1s. I am glad they worked out for you. We have since moved on to Suzukis and 600 hours in the first summer (2021) zero issues.

Dry burn= fragile.

Stupid title. BRP should do better.

If i had to choose between a boat with 2,3, or 4 of these or a pair of Cat / Detroit Diesels you can keep these pieces of junk. See which one lasts longer, costs less to run, and holds its resale value. i assure an outbaord engine can not even begin to compare.

@dayton191

Ай бұрын

You're comparing apples to watermelons here... The comparison makes no sense. Nobody would ever argue your statement. Tell me how many smaller boats

@MasterWitchDoctor

Ай бұрын

@@dayton191 its "Evinrude" and Ive been on sooooo many work boats with 12V71 TA's (650 hp) in them I cant even remember them all. When you have a 35, 40, or 45 foot boat with 5 or 6 outboards hanging off the stern it starts to look retarded. The cost of these outboards being upwards of 90 grand each vs 45,000 for the 12V71 TA (with a 2 ; 1 Twin Disc transmission) my former boss put in his 48 foot Marine Management makes these outboards look bad. You cant take these boats where he took his and i assure you they dont ride like his did either. So you have a sea plow (a name we gave Hatteras years ago because of how they plow through the waves) big deal, its no 54 Bertram. Im comparing common sense to this, these modern boats are a million dollars or more and burn fuel like crazy. A Cat C18 makes upwards of 1100 hp (unlike a 12V71 TA which at best makes 900 hp) and has more torque than all those outboards combined. Give me an inboard diesel all day long and yes that goes for Shamrock and Morgan who makes a 24 footer with diesels in them too.

Wå

nice click bait

Ours has the over heating issue. Has had since new. The engine is great when it wants to. Even just leisure boat ride the heat alarm goes off. Some trips it’s worse than others. It been to the dealer simply clearinghouse computer of the codes. It’s not a water pump issue. These engines to beat epa rules runs em hotter. Engine is great on fuel etc. my dad is waiting till the engine goes. Their will be a mercury 150 at some point. Dealer can’t replicate the issue because it’s that random. Don’t buy these engines g-2’s loads of new owners had trim issues after issue. I’d prefer a life time warranty just run the engine they fix it. When it’s this bad they ought to replace the engine period. Yes they’ll make them till the end of 2020 just parts after. With us not having a local mechanic certified they ought to come to you.

WTF

my etec 130 , at 220 hours mechanical proplem in fuel injector about 600 euro each,i need to change two of them the motor has six!All my friends has etec they have problems .

@ganerboss900

2 жыл бұрын

Six????? 130v4?

First of all the engine in the video is NOT a G2....the G2 replaced the engine in the video. Secondly, Robbins Marine....."taking care of boaters and their families for over 55 years" ???? Gee I wonder how many franchise agreements he has for engine manufacturers other than Evinrude....maybe he can't handle the competition ??? As an ETEC G2 owner I can say there is no competition, ETEC blows everything else out of the water in ALL categories, performance, power, maintenance cost, operation costs....the list of advantages is endless. The title of this video is absolute B.S.

@george14756

5 жыл бұрын

Frank Olivier you’re so butt hurt over this. Want a tissue?

e tec my asss

they junk they keep breaking

@ysteinsvendsen1246

4 жыл бұрын

How do you know?

i agree with rhis vid

just a pack of lies,worst engine in the world never buy johnson or evinrude same engine but different names hopeless shit