This was a very informative video. I had always wondered what it would be like to help a calm, soft-spoken dad, and the wet kit information was nice too.😜

This is a great detail video of PTO installation. Thank you.

Good video check backslash before tightening the pto bolts forgot to check when tight I would check it after been installed

This video is awesome! I never fully understood how a pto is connected but you made it all perfectly clear! Thank you very much for making the video!!!!

Hi great video. Question: can the RETURN hose be half way into the tank or does it have to be at very bottom of it ? thank you.

Thanks for this video

anyway to speed up dump action and when you lower the box? without reving the engine up?

Did you have to do any reprogramming for the 12 speed? Has the transmisson thrown any fault codes since installing?

Hi I have a question Eaton still covering your transmission warranty if you installed pto wet kit

That bracket and drain fitting is called an anti spin kit. Kenworth tanks are notorious for rotating and that is their solution.

hello where did you buy that bracket for the filter and the coupler mount?

Out of curiosity, why not keep the fuel tank and add a hydraulic tank up on the catwalk? Or is there room to mount it in between the frame under the catwalk?

My neighbor is having this installed on his truck. I’m building all the hydraulic lines for it. So my question is are your crimp fittings going to and from the pump JIC, Males O-Ring Boss, Male Pipe, Flat Face Seal?

@quicktanklines

Жыл бұрын

So the crimp fittings are only for the suction hose, all pressure lines need to be JIC.

is this installed so you can use a live bottom trailer?

What's the part number for that pto?

What trailer is that!?

My 2021 579 set up the same

was it a noisy engage

Want to install pto on my DT12 transmission

@FernandoRomero-ch9lk

2 ай бұрын

How am I able to do that?