The EGR connection pipe - I bought one on eBay made of aluminum instead of plastic(great stuff, you'll have it for life). My old one cracked to many pieces.

I appreciate the upload. Your videos are very informative. I’m currently an apprentice and I heavily rely on videos like yours please upload more regularly if you can it’s tones of help. Thank you

Love your videos; so informative. I have my first Volvo engine (2014 D13), and have little knowledge on best practices for repair. All your vids are saved to my "Favourites" play list for future reference, when the time comes. Please keep 'em coming...knowledge is power 🙂

@cardinaltruckservice3753

6 ай бұрын

Thanks for watching!

best video and mechanic 🔥 🔥 🔥 Greetings from Charlotte North Carolina

Thanks you for your help! Good job 👍

Very nice!

Thanks for the video

exselente trabajo master mui bueno

Great job thanks 👍

Thanks

Good job bro 👏

Great video; great guy; i did learn things from his KZread; i think is possible to clean cooler on the truck

I have a 2010 volvo d11 I just. Bought it and I didn't know it needs to be replaced my question is could I block the anti freeze ports and leave open the exhaust egr thanks

You’re a wizard

@cardinaltruckservice3753

6 ай бұрын

Inconceivable!

first like then watch your video

Great video for cleaning EGR cooler on the D13 engine. I have a 2017 VNL 780 with a D13 and had to fix a coolant leak coming from that plastic connection pipe joint. I didn’t have to remove the EGR cooler to fix the leak. It would have been nice to see your method so I could have cleaned out my cooler. I didn’t want to remove the turbo so I just replace the pipe and o-rings. Unfortunately my truck is at that mileage where all the after treatment components need serviced and the dealer charges thousands for any of these repairs. If you have any tips on saving money when it comes down to after treatment system let us know. Thanks for the informative content.

@ismaelhernandez9631

2 ай бұрын

How did you do it I have the same issue where the plastic pipe is leaking

Excellent videos highly educational what I personally would like to see is Volvo D13 camshaft removal and reinstallation especially the gear part it. Is it possible to install the camshaft without using the special gauge to measure the gear slack off the camshaft gear and the gear that drives it. Thank you so much.

@cardinaltruckservice3753

6 ай бұрын

I think if you just replace cam and did not remove cylinder head the clearance will stay within guideline. The guage is not special and just a shim to make sure you set clearance correctly. I'll make a video once I get one that needs cam

😎

Replace that plastic connector with the steel one, it will save you some headaches in the future

Total tme on this repair, 5 hours?

where are you located,?

Good job brother

I never had to lift motor on my '12 just remove the brackets for the cooler and twist and roll the cooler out

Man I did the same and off course we both got that mouth I also broke the stupid sensor lol

That horseshoe pipe is a nightmare to prevent from leaking either at idle or under load Its tha collar on the pipe itself on the lower portion

What is your shop address

Approximately how high did you lift the engine?

@cardinaltruckservice3753

6 ай бұрын

I haven't measured because I only lift just enough until I can get the cooler to fit. I think about 3-4 inches. You can probably gauge by looking at the driver side charge pipe and see if it's getting too tight.

@randallmercer4995

6 ай бұрын

Thank you

@branstz

2 ай бұрын

Good job sir . Thx