Volvo Angle Gear aka Bevel Gear Flange Change

Video demonstrating compatibility of late P2 angle gear with early P2 flange. I needed to replace the angle gear on my 02 V70XC but preferred to use a newer angle gear. I removed one from an 07 XC70 at my local wreckyard and was able to confirm that removal and replacement of flange is possible.

Пікірлер: 12

  • @AutoAgitator
    @AutoAgitator3 жыл бұрын

    Thanks for the video! What are the flange diameters ?

  • @98XC1
    @98XC1

    I thought that angle gears are different on 01-02 models and newer models due to different gear ratios. Also the torque for the pinion nut is between 138-147nm if my memory on vida spec is correct

  • @ellefields8878
    @ellefields8878 Жыл бұрын

    Thank you for this, I have an 01 V70XC and can’t find a decent transfer case anywhere meanwhile there’s plenty of 04<06 XC70’s all over the place. Looks like I’m going to head out to the salvage yard tomorrow and pull the best on I see off.

  • @russellp73
    @russellp733 жыл бұрын

    Also going through the same thing. What were the inside diameters of the flange that accepts the cv joint from the prop shaft? I have an 02 s60 and my flange accepts the 86mm cv joint. How did all this turn out? Did a seal from an 02 fit?

  • @t0bbster
    @t0bbster2 жыл бұрын

    I’m doing the same thing. Do you know the newton meter for the nut holding the flange and preloading the bearing?