10:59 if you have a good printer, improvement from opt out autocooling for outer walls will probably only be visible on glossy prints.

@minimal3dp

6 күн бұрын

Thank you for the info. I pinned your comment.

I’m having an issue with the nozzle scraping the infill. Orca did not seem to care if I had zhop enabled or not. I changed the infill pattern to get it to stop but there has to be some setting that will fix it for all infill. All prints look good. No other issues. Any ideas? FF AD5M. Orca-FF and Orca 2.1b.

@minimal3dp

6 күн бұрын

There should be a setting for zhop distance. Try to increase that and see if it helps. Let me know.

With Orca I kinda like 3d honeycomb over adaptive cubic, but I haven't done a lot of testing.

@minimal3dp

4 күн бұрын

I will take a look at it. I appreciate the feedback.

Hi. Where do you go to setup, or remove filament??

@minimal3dp

13 сағат бұрын

There is a filament section in the slicer settings. You can also go through the setup wizard and check and uncheck various filaments.

As of this If you have an older Mac hold off on the update of 2.1.1 as there are issues that they are working on.. Crashes and does not start

@minimal3dp

2 күн бұрын

Thanks for the information..

Does it support Voron 2.4?

@minimal3dp

7 күн бұрын

The is a voron 2.4 profile. I am currently building a corona, so I have not tested it directly.

I wish I could change the look. I hate that green/gray color scheme. Yes I know that there is a dark/light option.

@minimal3dp

5 минут бұрын

I liked the old logo better. I like dark otherwise.