UHMW installed on the Jet Stream Buccaneer 12'
Фильм және анимация
Episode 3 of building the 12' mini jet boat buccaneer boat from jet stream. Follow along as myself and Shep build this boat. We cleaned up the bottom for the uhmw install and put 3/4 of it on, Pt2 we will finish off the bottom.
Boat:
12' Buccaneer from Jet Stream Adventure Boats
Langley, BC, Canada
Music:
Cross my heart & hope to die - Martin Carlberg
Fame- Native 51
Other Social Media :
Instagram - @mini.jetboats (build page)
Instagram -@pnw.jetboats
Facebook - @pnw.jetboat
Thanks for watching and stay tuned for more.
Subscribe and Like :)
Пікірлер: 17
The welds are grinded down?
Good afternoon. where to get such a kit?
What tools did you use, how did u get the board that big? Questions i feel should have been gone over in video…..
How were you able to bend up the uhmw too match the metal bottom? Looks spot on. Very professional.
@PnwJetboats
2 жыл бұрын
It comes pre cut and bent. But if you don’t do it right away it’ll lose its shape. Had to bring it down to buddy’s shop and bend it again to bring the shape back.
@timothycripps2721
Жыл бұрын
@@PnwJetboats Did you just use a brake press to put the shape back into it?
Did you get the engine in ?
Did you use any glue/bond under the uhmw before drilling/bolting?
@PnwJetboats
2 жыл бұрын
Nope just a clean surface. Cleaned all the shavings and slapped it back on.
What is the thickness of the hull? Do you think I could apply the UHMW to my boat with a factory .100 Hull?
@smokeshow1984
6 ай бұрын
No point, uhmw doesn't add much strength. You could have 1in thick an your boat will still dent up an crack. You have to ad a bunch of stringers an replace the whole impact area with min 3/16(.188 I think). if you don't know where the impact area is .... take your boat out and run some skinny water- any place with a dent or good scratch should be 3/16 - 1/4 if you got the hp.
Screwing around Aaa
Did you just tap the hull and screw into that or did you end up putting nuts on the inside?
@PnwJetboats
2 жыл бұрын
Drill Tap Counter sink the uhmw Then yes stainless rubber washer and nylock nut to finish it off. Alittle grease tread too
@kenbrake2828
2 жыл бұрын
@@PnwJetboats nice!
3/4 or 3/8? 3/4 would be a chunky boi hah
@PnwJetboats
2 жыл бұрын
1/2” uhmw