Top job thank you Peter, this helped me fix a vivaro same issue

@kennedysgarage3281

Жыл бұрын

Brilliant, it just makes motoring life that little easier if we all share a little bit of information. Well done on fixing the issue 👏👏👏💪

Thanks Peter, that's useful to know. Been cleaning and testing the injectors on my 94 Jaguar XJS today. Mazda 6 still running great after I did the decoke. 👍🏻

@kennedysgarage3281

3 жыл бұрын

That’s great Dave, was there much stuff in the manifold?

@cebudave

3 жыл бұрын

@@kennedysgarage3281 loads of it, very supprised as the car had only done 56k dual carriageway miles on good quality diesel; the main blockage was in that removable egr flow pipe in the manafold.

@kennedysgarage3281

3 жыл бұрын

@@cebudave yes , it’s amazing how much builds up inside the intake manifold, well done for doing it though. Prevention is far better than trying to find an issue after it gets blocked up. Thanks for watching 🙏👍

Thanks for sharing. I have an 05 trafic showing low fuel pressure and started cutting out friday. Drive few minutes and it cuts out again. Very hard to start it. I changed the fuel filter but no better. This looks like it could be the culprit.

@kennedysgarage3281

3 ай бұрын

It would be well worth a try, good luck with it 🤞🤞🤞

Very nice explanation. Thank you for sharing.

@kennedysgarage3281

2 жыл бұрын

And thank you for your nice comments 😉👍

Nice explanation mate

@kennedysgarage3281

3 жыл бұрын

A late Friday evening rush video, didn’t have anything interesting lately & felt it might interest someone. Thanks for watching & commenting though Matt I really do appreciate it 👍😉

Nice one mate , thanks for sharing 👍

@kennedysgarage3281

10 ай бұрын

Hopefully it helps you out 👍👍

Very informative 👍

@kennedysgarage3281

3 жыл бұрын

Thank you Kevin 🙏👍

nice video thanks for sharing.

@kennedysgarage3281

3 жыл бұрын

Thank you John 🙏👍

Nice.

Good one Peter

@kennedysgarage3281

3 жыл бұрын

Thanks Dave 🙏

Did not solve my problem but where o get p0191 but the explanation clears the way it works thanks

@kennedysgarage3281

8 ай бұрын

I have seen the pick up in the fuel tank to block too. Check for low pressure fuel delivery to the pump to confirm first 😉👍👍

Ciao ho un primastar del 2004. Il motore si é spento durante la marcia e non sono stato capace di avviarlo. Portato dal meccanico con il carro attrezzi. Segna errore pressione carburante. Secondo te se cambio il sensore, ritorna tutto ok? Grazie👍

Thanks. May I ask where you get those volt-meter probes from ? They look really handy.

@kennedysgarage3281

2 жыл бұрын

I got them from Diagnostic connections, but I do find eBay very handy too, cheers Jack 😉

@jackspratt4343

2 жыл бұрын

@@kennedysgarage3281 Thanks Jack

Nice video, could this also trigger DTC P0002 codes?

@kennedysgarage3281

4 ай бұрын

I would suggest NO, but I could be wrong. That would most likely be the inlet metering valve on the fuel pump 🤔🤔🤔

Hi Peter, could this problem with the sensor cause the van to idle but not rev when warm? It does eventually rev but I notice the idle speed is low then gradually creeps up to about 800 RPM then it will rev ok, or if your on a hill and increase the RPM in gear that way. I'm waiting for a new accelerator pedal thinking it could be that. Thanks

@kennedysgarage3281

Жыл бұрын

If yours is the 1.9d engine, the most common issues with them running wise is EGR valves & Airflow meters. But both of them normally create fault codes, have you a EOBD code reader ??

@acewelding

Жыл бұрын

@@kennedysgarage3281 yes it is the 1.9 thanks for the reply. I’ve blanked off the EGR and tried 3 different MAFS. No fault codes register. I’ve ordered a the pedal to see if that works, but as the fault seems to happen mostly when the engine is hot I don’t think it will solve the problem. It wouldn’t happen if I could increase the idle speed.

@mr1martin1

7 ай бұрын

+ the hose of the TC pressure sensor being clogged.

@acewelding

7 ай бұрын

@@mr1martin1turbo pressure sensor hoses?

@zukhrufhussain2271

3 ай бұрын

@@aceweldingdid u ever manage to fix your van?

If this is faulty will it stop the high presure pump from working

@kennedysgarage3281

7 ай бұрын

It doesn’t stop the high pressure pump from working but it does limit the ability it has to produce pressure if it doesn’t know the fuel pressure 😉👍👍

I have a 1.9 Diesel Renault Trafic '06. Disconnecting the pressure sensor and probing with a volt meter, gives me 5 volts on pin 3 , when pin 1 is ground. Now, when I probe the middle wire of the connector, I get 15 mV D.C and not the 4.9 volts that you recorded. Any ideas? Thanks ? Do you think I should change the pressure sensor ?

@kennedysgarage3281

2 жыл бұрын

It sounds like you have a broken signal wire or it is shorted to ground. You will need to do the same test at the ECU connector & see the results, that could be interesting 🤨 Let me know what you find please Jack 🤔👍

@jackspratt4343

2 жыл бұрын

@@kennedysgarage3281 Hi Jack. I am only an hour away from your garage, so if I may, I'd like to book it in with you. I think it's either this signal wire to the fuel rail sensor, or, the fuel rail relief valve being faulty. I have a salvage fuel rail coming from the UK. If I could book it in for the next several weeks then I appreciate your expertise on sorting out my van's starting issue. Let me know and I will phone you. Ta

@kennedysgarage3281

2 жыл бұрын

@@jackspratt4343 Morning jack, my name is Peter & yes that is no problem whatsoever. Does you van run ?? Is it only hard to start ??

@jackspratt4343

2 жыл бұрын

@@kennedysgarage3281 Hi Peter. The van won't start at all under it's own volition. But, does start straight away using a can of Easy Start. And once going, so long as it's still warm, can stop and start as per normal. Once cold, it's back to the Easy Start.

@jackspratt4343

2 жыл бұрын

@@kennedysgarage3281 It runs perfectly once started.

From memory I thinknits 0.6 volts with the key in rising to 2.4 volts ro tell the ECU ro power up the injectors ?,learned myself after my garage couldn't get it going,,new sensor and away it went !

@kennedysgarage3281

Жыл бұрын

it feels good when you’re stuck on a problem and then figure it out after a few days of turmoil 😂😂😂😂 Well done mate 💪💪

Does 0.5 to 4.5 apply to most 3 wire sensors

@kennedysgarage3281

3 жыл бұрын

The pcm/ECU needs to know if circuit integrity is good so this applies to all sensing circuits but there has been 1 or 2 egr systems on Audi’s that had a 1 volt minimum that set fault codes, any more questions just ask, thanks David 🙏

@davidwaters5348

3 жыл бұрын

@@kennedysgarage3281 shall do thank you for your time

@davidwaters5348

3 жыл бұрын

@@kennedysgarage3281 hi Peter need advice please ...just taken a dpf off and cleaned it with soak solution...you have to tell the car when a new dpf is fitted ...do you need to follow same procedure after its been cleaned ? Thanks

@kennedysgarage3281

3 жыл бұрын

@@davidwaters5348 yes, reset everything

@davidwaters5348

3 жыл бұрын

@@kennedysgarage3281 thanks Peter was bit unsure

Is not Bosch sensor,right? Denso? Tnks.

@kennedysgarage3281

2 жыл бұрын

I cannot remember what brand the sensor was but it doesn’t matter what brand they all work the same 😉👍

unplugged 5v 5v grd middle is signal wire plugged in ignition on ,,,plugged in 5v .0449v grd will run on easy start then dies

@kennedysgarage3281

10 ай бұрын

Open off an injector pipe and see if you have any fuel when cranking 🤔🤔

can i just put a new sensor in ours cause i know mine is bad , once done do you need to clear the fault or will it just kick in my friend thanks in advance

@kennedysgarage3281

Жыл бұрын

Yes, if you know the sensor is bad just replace it and it will work straight away. The fault will still be stored but will become a history fault once the ECU sees the issue resolved. Cheers Ian 🙏

@lock411

Жыл бұрын

@@kennedysgarage3281 ok thanks you so very buddy for your help and support. Keep up the great work my friend 👍

@kennedysgarage3281

Жыл бұрын

@@lock411 thank you Ian 🙏😉

@lock411

Жыл бұрын

@@kennedysgarage3281 still not starting replced every sensor now in the engine lol

@kennedysgarage3281

Жыл бұрын

@@lock411 take off the air intake pipe & see if it start on easy star, if it runs the engine itself is ok 👍

position crankshaft sensor primastar cv 100

@kennedysgarage3281

Жыл бұрын

I’m sorry but I don’t understand ?? Is your crank sensor after failing 🤷🏼‍♂️

@moisesmanzano

Жыл бұрын

@@kennedysgarage3281 hola la ubicacion pregunto donde se hubica el sensor del cigueñal en una nissan primastar 1.9, gracias

@moisesmanzano

Жыл бұрын

@@kennedysgarage3281 lo que quiero sabe dondee va en que sitio va del motor es decir en mi nissan primastar motor 1.9 en que zona va si va la iquierda o al lado de la distribucion o en que parte se aloja en mi caso con mi motor , si va al lado del motor en la caja de cambio donde la campana en fin donde va a lojado, gracias

Signal usualy is midle

@kennedysgarage3281

3 ай бұрын

Correct it usually is in the middle 😉👍👍