Hello Dr. Andalibi, I hope you're doing well. Thank you for creating such an informative video. I came across it on my KZread homepage and since it covers my favorite topic, I watched it all the way through. I noticed a few typos in the final drawing that I wanted to bring to your attention. Firstly, there is a distinction between the meanings of A-B-C and A|B|C, and the same applies to A-B. I believe you intended to use A|B|C. In Solidworks, you should click "Add Datum" multiple times and write A, B, C. Secondly, the drawing is not composite tolerancing, but rather two-segmented position tolerance, as the meanings differ. For composite tolerancing, you need to combine both position tolerances into one.

@mehran1384

7 ай бұрын

Hi Dr. Alamdari. Thank you so much for your attention, expertise, and feedback. I just published a new video and clarified these two issues.

Hello, I'm an engineering surveyor. I found very interesting this video. I have a question on how are the measurements made? Thank you.

This is not composite position tolerance... this is single segment position tolerance