Hi, We used the Fireye scanner in the vessel. In Port side Boiler trip due to Flame Scanner B - Flame On Input Fault. Based on our analysis, normally Boiler trip shouldn’t be happened because Flame Scanner A able to Back-Up (every Boiler has two flame scanners : A & B). We trying to check related Wiring Diagram that we have, and we can see Flame Relay in series with Fault Relay. How we can rectify?

My appliance currently uses spark plugs for flame detection, but detection fails a lot. Is there a position that the spark plug should have or will I have fuel problems?

Where is the fire eye in my furnace. And hawe do I clean it.

I have one that works for 10 days and then magically Locs out and you cannot reset it unless you kill the power you can push the reset button all day long it will not reset you have to kill power to the unit and then hold the reset button in after you repower it up seems like some kind of software glitch or electronic issues I replaced this control with a new one and I do not have this problem anymore I would like to get this old one repaired is that something you can do

@filc-gmail9257

4 жыл бұрын

Jon, we do not recommend that any repairs be done to these units as consequences could be bad. You can, however, trade-in the unit for another one. Usually, you get an extra discount for the trade-in. Ask your local distributor if they participate in this plan.

@jonminnella2966

4 жыл бұрын

@@filc-gmail9257 okay how much is that

@filc-gmail9257

4 жыл бұрын

@@jonminnella2966 send us an email to sales@indeco-tx.com to my attention with the model number of your controller and ask for trade-in price. Also, let us know where you are located (City and state).

@jonminnella2966

4 жыл бұрын

@@filc-gmail9257 okay I will do that

First