Thank you, I just installed a new Takagi WH, I had the water backwards, took your advise and it worked. :).

Thanks dad. The power company hit the main water line and gas line. The water company came out and did some repairs and I had no hot water after that. The filter was full of sediment. I took the filter out and let the water jet out for a few minutes. Had hot water right after that. 👍🏽

I got a sidebar troubleshooting tip! I have a “master” mixing valve under my bathroom vanity sink closest to the hot water heater. When the mixing valve fails it’s suppose to fail on the cold water delivery feed so as not to burn the user. My hot water issue was with my mixing valve not the water heater.

Not sure if my water heater is older than that it was installed in 2021 but I don't have that whole panel in the front that shows you the flow and all that is that something you buy separately?. I'm having a no hot water issue but I have a blink code it's blink code number three apparently that says igniter issue somewhere I read online and I can't figure that out I clean the igniter rods they seem to be getting spark but it won't ignite the water heater

@sarafox4375

2 ай бұрын

I had mine installed last fall and no hot water... it happens in the shower and kitchen. I'll be trying out some of these today. Thank you. If there is a chance you can show the maintenence on an actual installed one. That would be great. I almost flooded my basement. 😮

How do you get it out of standby mode?