I bought a liter of Sunlu Toughness after watching this video and now it now my go to resin for all miniatures.

Thanks for the review! Been looking to upgrade my resin from the elegoo pla like and it looks like I need to do some experimenting!

Thanks for the review! I ordered a bottle using your link, and I'm excited to give it a whirl. I, too, have been using a 10% Siraya mix, and a cheaper one-bottle solution is attractive to me.

Thank you, very useful. This might well encourage me to try the resin printing again as I was always disappointed with the brittleness of my minis.

Just got my Mars 4 9K Ultra up and running, still working on the resin it came with (which I am quite happy with). Was looking around for "hints and tips" on 3D printing and alternate resins and this video popped up. So I just ordered a bottle to see how it works.

I've been running pure Sunlu ABS for a while, and I really enjoy it! I love the black version the most, since it doesn't need any mixing regardless of how long it sits out, as opposed to the greys. I do have a bottle of Tenacious though, I should give the 10% a try.

This and the Jayo resin have been my go-to for several months now. It's super cheap and has yet to fail me outside of my OWN mistakes.

Great video

Interesting, sounds like this is a good resin without having to mix and worry about separation.

This is my kinda content!

Siraya Tech recently introduced a Fast Tough Gray to the US market. Like the Sunlu, it is a mix of their Fast ABS-like and Tenancious. You should do a comparison of the Sunlu vs. Siraya Tech Fast Tough.

i use anycubic uv tough and I've bent spears completely looped over 180 degrees without breaking as a test.

I have some of the Tenacious resin. It's good, but I've found it has to be 30-40% of the mix to make a difference. Looks like that Sunlu Toughness resin will be a better value because Tenacious is $$$.

Thanks =)

Actually the sunlu high tough 3kg is cheaper about €20 per kg I also like the Siraya fast but that one is too expensive. Unfortunately, the sunlu tough dimensional accuracy is low just like any standard resin, I still prefer the abs-like

Have you tested Sirayatech ABS-like fast + Tenacious? Or something like the Phrozen Aqua 4k + Tenacious?

@gaminggeek241

8 ай бұрын

That's an upcoming video for the Siraya Tech resin!

How about Nylon-Lyke?

Did you change your exposure settings from ABS Like to Toughness?

@gaminggeek241

6 ай бұрын

No, I have the same settings and they work for me.

I had tested this sunlu toughness resin...but seem rubber & soft....not hard or solid....may i know what your setting?

@gaminggeek241

6 ай бұрын

Try increasing your exposure time. I'm running 1.75 seconds per normal layer at .03 height.

Good stuff! I loved you in The Goonies and Indiana Jones 2!

@gaminggeek241

2 ай бұрын

Wait, you didn't see me more recently on Everything, Everywhere, All at Once?!😜

use Warm Water to get your Supports Off cleaner so there is less cleanup. those are brutal.

Honestly, even though it's a little more expensive, I'd rather just buy toughness for everything to avoid mixing or replacing the resin.