thank you. this made the task very simple.

What if your window doesnt go down? what would you do?

@treyteague7667

2 жыл бұрын

had this problem on a different car

@treyteague7667

2 жыл бұрын

it was stuck on broken metal later found out it was a salvage wrecked car 😂

Will you upload the video on how to install it now? It would really help thanks for uploading a very detail oriented tutorial video!

Such a good explanation, thank you. 🙏

I’ve done this before and it is a PITA. What type of grease did you use on the gear for the regulator?Molykote ai 6359 is recommended. Thanks

great job at showing detail i’m gonna fix my gf window now

hey richpin! I want to buy a shirt or 2! or show some support somehow! you've helped me multiple multiple times!

@unclefreddieDied

4 жыл бұрын

how can I show some support?

Nice job thanks. Any thing you can do for a Nissan 2014 Frontier pickup would be appreciated. Gbu you're the best.

@RichpinTv

6 жыл бұрын

I will keep a eye out for one.

These new regulators are much simpler design than the older version. What about the install video?

Im not sure if i like the handle in the door card, no clips may make the cables jump out when the car is older, if the car lasts that long ha ha :-D. That day looked bright enough but that wind may not have been so nice, if your kneecaps suffer from kneeling on the crappy ground, perhaps a small square stool or plastic milk crate would be helpfull to sit on :-). Again another very similar looking window lifter, perhaps one day all cars will have one standard model of lifter, if the manufacturers grow up a bit.

@RichpinTv

6 жыл бұрын

I am always looking for something to put on the ground so i am not kneeing in the lovely dirt.ha ha.

@unclefreddieDied

4 жыл бұрын

@@RichpinTv hey brother! this is probably the 5th or 6th car you've helped me with!!!

Funny when you have to replace the motor because it doesn't work, but first you need to lower your window using that motor. Appreciate the tutorial though.

@Whatteva

6 жыл бұрын

For anyone wondering - I found a solution. Through holes in solid part of the door you have to unscrew the metal cover of the motor and remove it, then remove the rotor. After that you should be able to manually push the window downward and unscrew it. In my case motor replacement was not necessary, I just had to lube a rotor a little bit. Works like a charm now.

@davidglass1005

5 жыл бұрын

@@Whatteva Did you drill the holes to expose the screws for the metal cover?

@unclefreddieDied

4 жыл бұрын

@@Whatteva thank you!

@antonmiguelvelasco2980

3 жыл бұрын

@@Whatteva could you show us where those holes are? Thanks!

Where do you work Rich? I’m curious