Very informative video! Thanks you sir

I really appreciated these videos.

Thank you , very professional .

We will be using your guys products.

Hi this is Jose Nava from Sonoma California, work for Recology in Petaluma California, and we have Problems with the Double nuts with the Spacer. I want to know the TORQUE SPECIFICATIONS on TORQUE and setting those bearings.

Awesome videos

"righ off" very precise

Very informative.

Thanks for this video's sir

Are you guys doing any in-person wheel end classes again? P&B Intermodal in Tacoma needs you.

Thank You

Good

Deseo ver un ajuste de rodamiento en el eje steering ..con trae un espaciador,

What’s that part number on that wishbone to hold semi grease?

@trewright1482

Жыл бұрын

102-5015 is the Grease Template Part Number

If the red plug popped out of the stemco cap and it was missing what should be some of the reason to cause it

@niles.a2917

7 ай бұрын

Likely a plugged vent hole inside the red plug. Carefully inspect your components as the heat generated to cause that much pressure to build up is likely a sign of failure.

How do I get a certificate?

Is this for drive axles?

@trewright1482

Жыл бұрын

STEMCO makes Seals for Drive, Steer and Trailer Axles. This procedure works for all axles

@zues2013

6 ай бұрын

Same procedure but how much you back off the nut varies from trailer to drive axels on tractors refer to stemco website for all procedures

I’m surprised at how many are supposed to be competent at wheel bearing assembly. For some reason fail . I see a lot of bearings with excessive clearance at the spindle . As this is a slip fit,, not a wobble fit or press fit . Just measure then put new bearings on .or new spindle or axel . I’ve seen over 1/8th inch . Clearance. This is US standard measurement. No metrics here ,, I can but won’t use metrics .

ㅡㄷㄷ

no thank you