Continuing Sherco 2.9 Trials bike repair after kickback on starting damaged drive train components.
Жүктеу.....
Пікірлер: 9
@buhigasjam13393 жыл бұрын
Hola la varilla del embrague que va en el centro lleva dos arandelas.Como se posicionan y en que sitio van colocadas? Gracias.
@AngeltheDevilStuntАй бұрын
45 foot pounds?? The manual take 4,5 foot pounds or 6 Nm Are you sure of that?
@FuggyFilms Жыл бұрын
Steel City thanks for the vid. I've got the same Sherco with a clutch that is worthless until the bike is warmed up, then it works fine. Wonder if my plate gap is off or my slave cylinder just needs a rebuild. Thoughts?
@steelcitymechanical3902
Жыл бұрын
Check the wear on the clutch plates and basket. I have seen severally worn plates or baskets with worn out fingers cause clutches to get hung up.
@FuggyFilms
Жыл бұрын
@@steelcitymechanical3902 Thank you sir!
@backkraker114 жыл бұрын
hi, I live in USA washington state and was wondering if you know of any good mechanic for my sherco? thank you Joe
@steelcitymechanical3902
4 жыл бұрын
I do not, you might want to try Ryan Young products.
Пікірлер: 9
Hola la varilla del embrague que va en el centro lleva dos arandelas.Como se posicionan y en que sitio van colocadas? Gracias.
45 foot pounds?? The manual take 4,5 foot pounds or 6 Nm Are you sure of that?
Steel City thanks for the vid. I've got the same Sherco with a clutch that is worthless until the bike is warmed up, then it works fine. Wonder if my plate gap is off or my slave cylinder just needs a rebuild. Thoughts?
@steelcitymechanical3902
Жыл бұрын
Check the wear on the clutch plates and basket. I have seen severally worn plates or baskets with worn out fingers cause clutches to get hung up.
@FuggyFilms
Жыл бұрын
@@steelcitymechanical3902 Thank you sir!
hi, I live in USA washington state and was wondering if you know of any good mechanic for my sherco? thank you Joe
@steelcitymechanical3902
4 жыл бұрын
I do not, you might want to try Ryan Young products.
It's any joking or serious?