Hi Dave... I usually install aileron hinge line as 2 quarter inch pieces in the foam before I sheet the wing. I mark the hinge line with a T-Pin at each end of the hinge line, cut off so they just protrude through the balsa skin. After the sheeting glue has dried, you can line up a straight edge with the pins and cut through the skin on both sides to free up the aileron.

@aircreative

4 жыл бұрын

Hi broo.use wayer for whats?

Good job Joe!

What brand and type of glue do you use?

I have a set of similar foam balsa covered wings. Too heavy and wounder if there is an easy way to cut holes to lighten the wing.

The carbon fiber is .007 unidirectional carbon laminate available through ACP Composites.

How do you create, prepare, and install the control surfaces on your balsa covered foam core wings?

Dear sir lovely work, how do you conect both half wind together with dihedral?

friend you make helicopter blades? you send pro Brazil? I'm crazy wanting one of these

Great video, thank you for uploading it! Couple questions....What kind of fiberglass and and casting resin are you using? What are you going to coat the balsa with?

@joedunnaway

8 жыл бұрын

The wing can be fiberglassed and painted after sheeting but I usually cover the wings with Monokote. The wing shown in this video ended up weighing 11.9 oz with a JR 9411 servo and linkage (Ready to Fly).

@lookylou6333

2 жыл бұрын

can the wing be repaired after a crash if the 2 halves fit ? if so how?

ciao Joe, what brand and type of glue do you use?

is balsa sheeting a couple of pieces glued together

Hi from spain, what kind of glue do you use in order yo joint the balsa to the foam core ¿?

@user-tk9ug2rj3z

5 жыл бұрын

ចង់ធ្វើយន្តហេាះដែររៀននៅណាពួ

What material is this dark that you cut at the beginning of the video? thanks..

@XFBO

3 жыл бұрын

carbon fiber veil, lightweight material that adds a bit of strength to wing.

3:03 balsa dust cough, I know it well.

What kind of carbon fiber material are you using?

@joedunnaway

8 жыл бұрын

The Carbon Veil weighs .3 oz per yard and is available through ACP Composites.

what glue do you use?

Where is the rest of the video?

what is thickness ok balsa sheeting

what glue is that please?

What thickness balsa is this?

@camaro92026

6 жыл бұрын

Thomas Greenhill 3/32

@joedunnaway4728

4 жыл бұрын

16th inch Balsa... There are 4 more videos prior to this one showing sheeting and foam core preparation.

@x.a.m1960

2 жыл бұрын

I'am no balast you balast?

can man fly with these wings?

I wouldn't buy into the carbin fiber info you heard. Carbon fiber gets its strength from multiple cross hatched layers held together with epoxy. Better off using just Monikote or typical laminating film.

Hello! Can you help me to send a plan over what I need. Or were on the Internet I can download? ? ? ? ? ? ? ? ? ? ? ? ?

@mohamednacir7989

8 жыл бұрын

+Moh e amed Nacir

Un Cuarto de HORA de Vídeo = 15 minutos, para ver como enchapa, un Corte de Ala de/en FOAM.