SCULPFUN S30 Ultra-22W Laser Engraving / Cutter - Impressions
Ғылым және технология
Here is a quick impressions review of my Sculpfun S30 Ultra.
sculpfun.com/products/sculpfu...
Glasses
www.amazon.ca/dp/B00UJBGUMM?p...
Respirator
www.amazon.ca/dp/B087FCW79Y?p...
For cutting acrylic setting I used are
- 1250mm/min speed
- 5 passes
- 100 Power
Support me on Patreon
/ rolohaun
My Merch
www.rolohaun3d.ca/merch
Пікірлер: 6
Glad you called out safety aspects of using a laser cutter. 👌Disappointing they don't even offer and enclosure. I really wish companies would take enclosures more seriously with these products.
The laptop hanging off the side of the table is giving me anxiety. LOL
@Rolohaun
10 ай бұрын
I promise a temp setup haha
looks like a great piece of kit could you try backlighting by spray painting over a piece of white piece of plastic and then engraving the paint
@Rolohaun
10 ай бұрын
ya I bet that would look cool
@fon-tijn
10 ай бұрын
@@Rolohaun the warthog project does a similar thing he uses an modified cheap k40 co2 laser cutter for it