Scag Tiger Cub Spindle Hub Bearing and Seal Installation
Жүктеу.....
Пікірлер: 7
@chrisbarnard638510 ай бұрын
Great how to video! Short and to the point. Mightve been beneficial to alot of DIY folks to show how to properly pack the bearing prior to installation. I agree this is crucial and may not be common knowledge to many folks without a mechanical background. Thanks for posting!!
@aggiejet
9 ай бұрын
Thanks! 👍
@madischulz Жыл бұрын
Great video!
@blaablaahi2 ай бұрын
Does anyone know if is this the same spindle on a Cheetah 61v?
@garylawson52304 ай бұрын
Did you set the pre load on the bearings
@aggiejet
4 ай бұрын
No, I just torqued the nut to 150 ft-lbs. Scag rebuild instructions that came in the driver/holder kit did not mention that.
@garylawson52303 ай бұрын
Instructions said do not remove inner snap ring in the housing
Пікірлер: 7
Great how to video! Short and to the point. Mightve been beneficial to alot of DIY folks to show how to properly pack the bearing prior to installation. I agree this is crucial and may not be common knowledge to many folks without a mechanical background. Thanks for posting!!
@aggiejet
9 ай бұрын
Thanks! 👍
Great video!
Does anyone know if is this the same spindle on a Cheetah 61v?
Did you set the pre load on the bearings
@aggiejet
4 ай бұрын
No, I just torqued the nut to 150 ft-lbs. Scag rebuild instructions that came in the driver/holder kit did not mention that.
Instructions said do not remove inner snap ring in the housing